MSF Written Test Questions & Answers

MSF Written Test Questions & Answers Give three reasons why motorcycling is more risky than driving a car. Vulnerability, Visibility, Judgment. What are some ways to prepare for the riding risks? Risk acceptance, Mental readiness, physical readiness, riding gear, understand your abilities/limitations, know your motorcycle and awareness of riding conditions. What does it mean to act responsibly? Demonstrate acceptance of and commitment to managing the risks of riding, helping reduce your chances of a crash, injury or death. What is the benefit of wearing apparel specifically designed for motorcycling Protection, comfort/cover, control. How does riding gear make a rider more comfortable? By protecting you from all elements. What is the difference between retro-reflective and reflective? Retro-reflective material: reflects light back to the source and illuminates the rider. Reflective, bright to make yourself more visible/visibility. Why aren't ordinary glasses or sunglasses sufficient eye protection? Do not provide adequate eye protection. What three things should you consider when shopping for riding gear? 1. Brightly colored/retro-reflective material. 2. Protection. 3. All kinds of riding conditions. Where do you find the recommended maintenance schedule for your motorcycle? Owners Manual What are the six primary controls and where is each located? 1. Throttle (right handgrip) 2. Clutch lever (infront of left hand grip) 3. Gearshift lever (infront of left foot rest) 4. Front brake lever (infront of right handgrip) 5. Rear brake pedal (infront of right footrest) 6. Handlebars What is the purpose of the engine cutoff switch and where is it located? Allows you to shut off the engine without removing your hands (right handgrip) What must you remember when using your motorcycle turn signal? Most models (motorcycles) do not cancel turn signals. How do you start the bike? 1. Turn fuel valve from off to on, turn ignition switch on 2. Shift transmission to neutral 3. Move engine cut off to "run" or "on" 4. Squeeze clutch before operating 5. Press the starter button How do you use the friction Zone? Gradually, slowly What are the elements of good riding posture? Straight back, head/eyes up, look forward, feet on footrests, knees against tank, relax arms, bend elbows, hands on controls. What are the four steps to turning? 1. Speed (S) 2. Position (P) 3. Aim (A) 4. Turn (T) Why is it important to look through turns? You go where you look What does lifting or pressing on the shift lever accomplish? Shifting from lower to higher gears OR Changing gears helps keep the engine within its operating range at all speeds. Which brake provides more stopping power and how much? Front brake 70% stopping power How should you release the clutch when downshifting? 1. Roll off throttle (R) 2. Squeeze clutch (S) 3. Press on shift lever (P) 4. Ease (E) How can you improve your visibility to other traffic? 1. Ride with your headlight on during daytime 2. Turn Signals 3. Hand signals What is the 20 second visual lead? 20 second path of travel What two words best describe scanning? An aggressive, purposeful search for information What is the recommended minimum following distance? 2 seconds low speed, anything less than ideal four or more seconds. What should you consider when choosing a lane position? Best position to see and be seen How does AAA help make you an expert Rider? Helps expert riders know what's going on around them and act early. Where do most multi-vehicle collisions occur? Intersections How do you check your blind spot? By turning your head What can you do to reduce reaction time in hazardous situations? Be alert, ready, space cushion, always have an escape route. How do you know if you are overriding your headlight? Going too fast to process what you're seeing. What are the leading causes of single - vehicle crashes? Failure to brake properly At what point should you turn toward the apex? Outside How do you link turns smoothly? Stay outside longer before the turn starts When should you turn your head for cornering? When you can see clearly through the turn OR Always How is the front brake applied to stop quickly in a straight line? Smoothly and firmly with increasing pressure. How is the rear brake applied to stop quickly in a straight line? Light-to-lighter pressure to prevent skidding.