Millwright prep level 4 conventional alignment Exam Questions With Verified Answers

Millwright prep level 4 conventional alignment Exam Questions With Verified Answers When equipment is aligned, the _________ are collinear - answerShaft center lines Rotating shafts are usually aligned with the ________ in Place. - answerCouplings The two ways that a coupling must be aligned are __________. - answerRim and face The outer diameter of a coupling is also called the _________. - answerRim Offset misalignment is also called _________ misalignment. - answerParallel Vertical offset occurs when one of the coupling halves is _________ the other. - answerHigher or lower than One of the units, the driver or the driver, must be tilted on its base to correct _________. - answerVertical angularity One of the units must be rotated on its base to correct _______. - answerHorizontal angularity Only one kind of alignment can occur at a time. - answerFalse The front feet of the driver act as a pivotal point for ___________ alignment - answerAngular The MTBM is usually the ____________ - answerDriver When the coupling is divided into four positions for aligning purposes, the top of the couplingsis in the ________ position - answer12