MN Boiler License Questions and Answers 2024

MN Boiler License Questions and Answers 2024 What is the maximum boiler horsepower you may take charge of on a chief engineer's license? - answerUnlimited A 1st class engineer may take charge of a boiler plant not to exceed - answer500 Boiler HorsePower If you were to fail a chief engineer's exam, how long must you wait before you would be allowed to take the test again - answer30 Days What should be displayed in the boiler room? - answerEngineer's License and Exemption or inspection certificates A 2nd class engineer may take complete charge of a boiler plant not to exceed...? - answer100 Boiler Horse Power T/F When determining what engineers license will be needed, the total horsepower connected to the common header is used - answerTrue In a boiler plant where there are two 250 horsepower boilers using heating surface connected to the same common header, what engineer's license would be required? - answer1st Class Engineer What shift engineer's license would be required for two 250 HP boilers using heating surface connected to the same common header - answer1st Class T/F A special engineer license is for high or low pressure boilers not to exceed 50 boiler HP - answerTrue To whom would you report a boiler condition you thought not safe - answerBoiler Inspector What grade license must the shift operator have where a chief engineer has charge of a plant of 500 BHP? - answer2nd Class An engineer with one year of actual boiler operating experience verified by affidavit would be allowed to take an exam for - answer2nd Class An engineer having an engineer license, with 3 years actual boiler operating experience verified by one or more affidavits would be allowed to take an exam for? - answer1st Class What is meant by high pressure boiler? - answerSteam or other vapor in excess of 15 PSIG or a water or other liquid boiler in which the pressure exceeds 160 PSIG or a temperature of 250 F What would a special engineer's license allow you to operate? - answerHigh and Low pressure boilers and their appurtenances of not more than 50 HP A shift engineer in a high-pressure, high-temperature hot water plant of 500 BHP must have a? - answer2nd class Grade A or B T/F The Division of Boiler Inspection may suspend or revoke the license of any master, pilot or engineer found under the influence of drugs or alcohol when on duty - answerTrue T/F Boilers found to be operated by unlicensed or improperly licensed persons shall not be used until the operators are properly licensed - answerTrue How often must you renew your high or low pressure boiler engineer's license - answerOnce every two years A company is monitoring boilers by remote electronic surveillance; do they need a licensed engineer for monitoring - answerNo, see Section 13.183.501 What equipment would you be allowed operating responsibility with a 1st Class Engineer's license Grade B - answerTotal bhp not to exceed 500 hp liquid or vapor boilers and their appurtences Four, 20 million BTU input hot water boilers are connected to the same common header. What license would be needed to be in charge of this plant? (temp of hot water is less than 250 F and pressure is less than 160 psi) - answerChief A, B, or C license What class and grade of license MUST the shift engineer have where a chief engineer has charge of a hot water plant operating below 250 F and 160 psig total bhp of 500 - answerA 2nd Class Grade A, B, or C license For the purpose of the rating bhp for engineer's license classification only, how many sq ft of heating surface shall be equivalent to one bhp - answer10 sq ft of heating surface What is meant by the term Low Pressure Boiler - answerBoilers operating at a steam or other vapor pressure of 15 psig lr less; or a water or other liquid boiler in which the pressure does not exceed 160 psig or a temperature of 250 F A special engineer may serve as an apprentice in what size maximum vapor boiler plant - answerIn any plant under the direct sup