American Home Inspectors Training AHIT Exam Questions and Answers

American Home Inspectors Training AHIT Exam Questions and Answers Flashings are metal or plastic sheets used at interfaces between building components primarily to - Answer-Prevent water penetration Flashings are most comply made of - Answer-Sheet metal Flashings are commonly used in all of the following locations EXCEPT - Answer-beneath windows Oriented strand board (OSB) is - Answer-Plywood sheathing Platform framing is considered to be better than ballon framing in all of the following ways EXCEPT - Answer-Platform framing results in more stable buildings Which of the following can happen as a result of condensation within walls? - Answer-Insect Damage. Peeling Exterior Paint. Rot. (all of the answers shown) Which of the following statements about platform framing is NOT TRUE? - Answer-In platform framing construction the wall studs rest directly on the sill plate. Which of the following can happen as a result of condensation within walls - Answer-Rot. Peeling Exterior Paint Insect Damage (all of the answers shown) Which of the following is a way for an inspector to identify framing problems in a finished house? - Answer-Peelings paint on exterior walls. Crack in interior walls. Sagging over large windows, (all of the answers shown) Planks of this size are commonly used to create studs in energy-efficient home because they provide more room for insulation - Answer-2 x 6s All of the following are true of truss uplift EXCEPT - Answer-it is a bigger problem in warm weather What are horizontal structural members that help to support the roof and prevent rafter spread by connecting opposite pairs of rafters - Answer-collar ties Layers of roof covering have been added to a sloped roof over time. To absorb some of the add- roof-load, rafters can be supported with any of the following EXCEPT - Answer-Joists In a flat roof, rafters are called roof - Answer-Joists All of the following statements are true EXCEPT: - Answer-the Inspector must always enter the attic space to complete the Inspection An Inspector should report which of the following if found during a driveway or sidewalk Inspection? - Answer-pitting, upheaval, and sunken areas trip hazard Negatives slope (all of the answers shown) What problem can be caused by poor construction, an insufficient base, tree roots, or stone moving to the surface after years of frost heaving? - Answer-Upheaval A patio should - Answer-slope away from the house All of the following statements about driveways are true EXCEPT - Answer-They must be paved Mud-jacking is a method of leveling a concrete surface by pumping grout or foam through the concrete from below to raise the surface. it can be used to repair what problem - Answer-Sunken areas Pitting can be the result of - Answer-an insufficient base. Stones moving to the surface because of frost heaving. tree roots (none of the answers shown) What deficiencies did you notice in the previous scenario #1 - Answer-The joints hanger is missing nails. How should the issues be reported - Answer-I recommend that a qualified contractor properly nail the joints hang