DCOM 220 Final Netacad Exam Questions and Answers with complete solution

DCOM 220 Final Netacad Exam Questions and Answers with complete solution What are two examples of network problems that are found at the data link layer? (Choose two.) framing errors encapsulation errors Refer to the exhibit. A network administrator has deployed QoS and has configured the network to mark traffic on the VoIP phones as well as the Layer 2 and Layer 3 switches. Where should initial marking occur to establish the trust boundary? Trust Boundary 1 Which communication protocol allows the creation of a tunnel through the DSL connection between the customer router and the ISP router to send PPP frames? PPPoE Which routing protocol is used to exchange routing information between autonomous systems on the Internet? BGP What is the result of a DHCP starvation attack? Legitimate clients are unable to lease IP addresses. What are two benefits of using SNMP traps? (Choose two.) They eliminate the need for some periodic polling requests. They reduce the load on network and agent resources. A small law firm wants to connect to the Internet at relatively high speed but with low cost. In addition, the firm prefers that the connection be through a dedicated link to the service provider. Which connection type should be selected? DSL (Digital Subscriber Line) Which feature is unique to IPv6 ACLs when compared to those of IPv4 ACLs? an implicit permit of neighbor discovery packets Refer to the exhibit. For which autonomous system would running BGP not be appropriate? 65003 RSPAN depends on which type of VLAN? RSPAN VLAN Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. A user reports that PC0 cannot visit the web server . Troubleshoot the network configuration to identify the problem. What are three configuration issues that are causing the problem? (Choose three.) Routing on HQ is not configured correctly. SW1 has a port configuration issue. One of the interfaces on Branch is not activated. Match the QoS marking field to its corresponding OSI mode( Layer 2 Experimental (EXP)