automatic transmission section 2 test: CH 4, 5, 6, With Complete Solution
automatic transmission section 2 test: CH 4, 5, 6, With Complete Solution Voltage generation devices are typically used to monitor rotational speeds. Which of the following is NOT a voltage-generating type sensor? MAP While discussing transmission solenoids: Technician A says the TCM relies on information from the engine control system, transmitted through such sensors as the MAP and TP sensor, as well as information from the transmission, to determine the optimum shift timing. Technician B says a TCC solenoid can be modulated to smooth the engagement of the torque converter clutch. Who is correct? both Technician A says throttle position is an important input in most electronic shift control systems. Technician B says vehicle speed is an important input for most electronic shift control systems. Who is correct? both Some transmission control systems monitor the speed of the input shaft and compare it to the speed of the output shaft to determine the _______________. line pressure, gear ratio, shift patterns While discussing various sensors used with an electronic transmission control system: Technician A says potentiometers are typically used to measure temperature changes. Technician B says MAP sensors are used to measure engine load. Who is correct? tech B Technician A says shift solenoids either allow or block fluid flow from the various apply devices in the transmission. Technician B says shift solenoids are used to mechanically apply a brake band or multiple-disc clutch assembly. Who is correct? tech A While discussing transmission adaptive learning: Technician A says this learning process allows the TCM to make adjustments to its program so that quality shifting always occurs. Technician B says the TCM learns to respond to the driver's driving habits. Who is correct? both Which of the following statements about electrical problems is NOT true? A short will cause the components in the circuit to operate poorly because of increased current flow to them. Excessive resistance at a connector, internally in a component, or within a wire will cause low current flow, and the component will not be able to operate normally, if at all.
Información del documento
- Subido en
- 21 de julio de 2023
- Número de páginas
- 12
- Escrito en
- 2022/2023
- Tipo
- Examen
- Contiene
- Preguntas y respuestas