NATE HEAT PUMP EXAM QUESTIONS WITH COMPLETE ANSWERS GRADED A+

NATE HEAT PUMP EXAM QUESTIONS WITH COMPLETE ANSWERS GRADED A+ Charging a heat pump with refrigerant is best accomplished in the _______ mode. A: Heating mode B: Cooling mode C: Defrost mode D: Emergency heating mode - ANSWER-B: Cooling mode Heat pumps can provide both heating in the winter and cooling in the summer. In which mode is the heat pump more efficient? A: Heating mode B: Cooling mode C: Defrost mode D: Emergency heating mode - ANSWER-A: Heating mode Which of the following components is exclusive to the heat pump? A: Condenser B: Oil separator C: Reversing valve D: Accumulator - ANSWER-C: Reversing valve Which of the following airflow rates is the most reasonable for a heat pump system operating in the heating cycle? A: 200 cfm per ton B: 300 cfm per ton C: 400 cfm per ton D: 450 cfm per ton - ANSWER-D: 450 cfm per ton During the heat pump's cooling cycle, the outdoor coil is utilized as a _________ while the indoor coil is utilized as a____________. A: Condenser, evaporator B: Evaporator, condenser C: Compressor, accumulator D: Accumulator, condenser - ANSWER-A: Condenser, evaporator Heat is present in winter outdoor air until the outside air ambient temperature reaches a low temperature of: A: 0 degrees F B: 32 degrees F C: 273 degrees F D: -459 degrees F - ANSWER-D: -459 degrees F Technically this is true, but not practical. A heat pump is doing good to continue to work below 10 deg F. The heat pump utilizes: A: Two filter-driers with check valves B: One bi-flow filter-drier C: A single mono-flow filter-drier in the liquid line D: Some use the bi-flow filter-drier and others use two filter-driers with check valves - ANSWER-D: Some use the bi-flow- filter-drier and others use two filter-driers with check valves The correct way to size a heat pump is to perform both heating and cooling load calculations and select the heat pump size by: A: Adding the heating load and cooling loads B: Subtracting the smaller load from the larger load C: Using the heating load to size the system D: Using the cooling load to size the system - ANSWER-D: Using the cooling load to size the system Auxiliary electric heat is necessary because: A: It provides heat for the home during defrosts B: It provides heat for the home in the event of a heat pump failure C: It provides heat for the home if the heat pump is unable to meet the demand for heat D: All of the above - ANSWER-D: All of the above Reading a voltage across the contacts of the outdoor thermostat means: A: The thermostat contacts are closed B: The thermostat contacts are open C: The thermostat contacts are stuck D: The thermostat contacts are working correctly - ANSWER-B: The thermostat contacts are open Which of the following is not a type of heat pump? A: Ground to air B: Air to air C: Water to air D: Direct coupled - ANSWER-D: Direct coupled