Construction Coordinator (with 100% errorless answers)
Why are pin-type hardline connectors the preferred type of connector for attaching hardline coaxial cable to equipment housings in today's networks? correct answers Over the years, intermittent operation, low-frequency roll-off, and common path distortion (CPD) issues have been attributed to feed-through connectors. What type of adapter is used for permanent or temporary jumper installation in place of damaged hardline coaxial cable or equipment hookup? correct answers Pin-to-F female adapters. What should be worn when cutting and preparing hardline coaxial cable for connector attachment? correct answers Leather work gloves. How should a knife be used when preparing hardline coaxial cable for connector attachment? correct answers To score the aluminum shield that must be broken and then removed. What is a consequence of cutting hardline coaxial cable with conventional side cutters? correct answers The end of the cable is crushed and deformed, which makes coring the dielectric and sliding connector parts onto the cable difficult. When using a single-purpose coring tool, what is done before the coring tool can be used to cut and remove the dielectric? correct answers The appropriate length of aluminum shield and dielectric must be removed, to expose the cable center conductor. If the hardline coaxial cable center conductor is too short after coring the dielectric with a combination coring tool, what should be done? correct answers Clean out any dielectric and aluminum trimmings from the cable and the tool and continue coring to the correct depth. What is different about preparing QR hardline coaxial cable for connector installation compared to all other types? correct answers QR cable is first cored and the aluminum shield is stripped before the polyethylene jacket is removed to the proper length, the reverse of other cable types. What can be said about a straight splice connector? correct answers It is essentially two hardline connectors with a common interface. How far beyond a pin connector should the shrink tubing overlap the coaxial cable? correct answers At least eight inches after shrinking. How can signal leaks (egress) from hardline coaxial cable occur? correct answers Through cracks in the shield where the cable is bent, or tiny holes in the shield. What is the return loss in coaxial cable? correct answers The difference in decibels (dB) between the signal power applied to a terminated cable and the reflected signal power.
Información del documento
- Subido en
- 30 de mayo de 2023
- Número de páginas
- 7
- Escrito en
- 2022/2023
- Tipo
- Examen
- Contiene
- Preguntas y respuestas