Exam (elaborations) QA Automation Testing and Manual testing bootcamp

Transaxle R&R is being discussed. Technician A says in some cases, flange-mounted drive shafts may be left attached to the wheel and hub assembly and only unbolted at the transmission flange. Technician B says never separate the lower ball joint from the steering knuckle as this may cause wheel alignment problems. Who is correct? correct answers a only The owner of a car complains that the gears grind when shifting into reverse. Technician A says the clutch has excessive free play. Technician B says there could be oil on the clutch disk facing. Who is correct? correct answers a only Technician A says an oil-soaked clutch disc cannot cause clutch chatter. Technician B says clutch chatter cannot be caused by loose bell housing bolts. Who is correct? correct answers neither a nor b Technician A says when a small gear drives a larger gear, output speed is decreased. Technician B says when a small gear drives a larger gear, output torque is decreased. Who is correct? correct answers a only When installing a ball bearing that is a press fit [tight] onto the main shaft, pressure should be applied to the _____ race. correct answers inner Which of the following could cause a clutch pedal pulsation? correct answers all answers are correct Technician A says a transmission noise is caused by something internal if it is most noticeable during a test drive. Technician B says the noise is caused by the clutch if the noise disappears when the clutch is disengaged. Who is correct? correct answers neither a nor b