CIP Level 2 NACE-CIP2-001 Practice Test Questions and answers 2023

CIP Level 2 NACE-CIP2-001 Practice Test Questions and answers 2023CIP Level 2 NACE-CIP2-001 - Coatings Inspector Program Level 2 CIP Level 2 focuses on advanced inspection techniques and specialized application methods for both steel and non-steel substrates, including concrete using both nondestructive and destructive techniques. Surface preparation, coating types, inspection criteria, lab testing, and failure modes for various coatings, including specialized coatings and linings are also covered. CIP Level 2 NACE-CIP2-001 requirement Certification candidates must apply for this certification by submitting an on-line application which is subject to approval. Certification candidates have four (4) years to complete all requirements, including a successful completion of the exam, and an approved application with the required work experience and education requirements. You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent. Your first course of action should to: A. Investigate to find the source of the odor B. Don your air supplied respirator and continue the testing C. Exit the tank and immediately and report the problem to the nearest safety supervisor D. Exit the tank and document the incident in your daily report Answer: C You are working as an inspector in a galvanizing plant for the first time. What are some of the hazards you need to be aware of: A. Risk of chemical exposure B. Risk of skin C. Risk of acid or caustic splashes D. a), b), and c) Answer: D You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved. Your FIRST preferred course of action is to: A. Verbally challenge the NCR B. Request a re-blast of the item in question C. Consult your supervisor D. Review the NCR with the other Inspector Answer: C An Inspection and Test Plan is required when: A. It is always required B. When the Coating Applicator requests one C. When the Owner specifies one D. When the Inspector requests one Answer: A The Inspectors' goal at the Pre-Job Conference is to: A. Obtain a clear understanding of the Specification B. Discuss contractual requirements C. Manage the meeting so it doesn't go off topic D. Take accurate meeting minutes for distribution Answer: A Coating Surveys are legally required: A. On commercial marine vessels and offshore platforms B. On high pressure gas lines and fireproofed structures C. On water tanks and potable water pipelines D. On food and beverage vessels and can linings Answer: A The cost of qualified Coating Inspection is normally offset by: A. Lower Application Costs B. Lower Coating Life Cycle Costs C. Lower Safety Enforcement Costs D. Lower Supervision Costs Answer: B Download NACE-CIP2-001 questions