MSSC Quality Practices & Measurement

Which type of feature is parallel to the surface being dimensioned? - AnswerDimension line The three standard views of an object are __________. - AnswerTop, front, right side Which type of lines are used to show the counterbored hole in the part? - AnswerHidden lines The number of views in a drawing __________. - AnswerIs the fewest number that shows all of the features and dimensions Which of the following steps is NOT used in the glass box method? - AnswerRotate object in glass box. What type of drawing is shown? - AnswerMultiview The dimensions of raw material supplied by metal suppliers are described by the __________. - AnswerStock size Which of these requires a computer? - AnswerCAD An isometric drawing is a type of __________. - AnswerPictorial drawing In the graphic shown, the two circles are __________. - AnswerConcentric Dimensions are used to specify the __________ and location of the features of an object. - AnswerSize What feature in the figure shown is a Chamfer? - AnswerD A __________ dimension is described in inches per foot. - AnswerShaft taper What is the order of precedence of lines in a drawing? - AnswerObject, Hidden, Center Which of the following is not one of the six rules for dimensioning an object? - AnswerDimension hidden lines Engineers sometimes use a __________ to measure angles on a drawing. - AnswerProtractor What dimension is indicated in this graphic? - AnswerHeight There are 60 minutes of arc in one __________. - AnswerDegree