Answers (Grade A+)
Question 1: Is an example of a common prying tool
Answer: Halligan
Question 2: An swinging door is indicated by the hinges being visible
Answer: outward
Question 3: Is an example of a pulling tool
Answer: sheetrock rake
Question 4: What is the Order of Priorities When Suppressing Structure Fires?
Answer:
1. Protect Exposures
2. Cut Off Fire Spread
3. Attack Seat of the Fire
Question 5: When Advancing a Hose-line into a Structure, Extinguish Any Fire That is Visible and
Answer: Accessible
Question 6: A Vehicle Fire Should be Fought from a Degree Angle
Answer: 45
Question 7: If You Are Advancing an Attack Line into a Structure and CANNOT See Your Feet,
You Should
Answer: Crawl
Question 8: What are the Appropriate Hose Sizes for Attacking a Structure Fire?
Answer: 2 1/2 and 1 3/4
Question 9: Directing Fire Streams Toward the Ceiling or Wall of a Room or Building in Order to
Generate Large Amount of Steam is an Attack
Answer: Indirect
Question 10: At a Structure Fire, the Highest Priority are Close Priority Fuel Tanks and Propane
Cylinders
Answer: Exposures
Page 1
, Question 11: A Attack is Discharging Water or Foam Directly onto a Burning Material
Answer: Direct
Question 12: When Extinguishing a Container Fire You Should Never Approach from Downhill or
Answer: Downwind
Question 13: You Should First Direct Your Fire Stream at the During a Combination Fire Attack
Answer: Ceiling
Question 14: The process of hauling water from a fill site to a dump site is known as
Answer: water shuttle
Question 15: Hydrants installed in areas with prolonged subfreezing weather are called
Answer: dry barrel
Question 16: The process of drawing water from a static source to supply a pumper is called
Answer: drafting
Question 17: Wet-barrel hydrants are always filled with
Answer: water
Question 18: In the Matanuska-Susitna Borough, the type of fire apparatus that carries fol-da-tanks
is
Answer: tenders
Question 19: Equipment needed for drafting:
Answer:
1. hard suction
2. barrel strainer
3. low level strainer
4. float-a-dock
5. rubber mallet
Question 20: All collections must be air tight to obtain a
Answer: vacuum/suction when drafting
Question 21: The main valve on a dry-barrel hydrant is located
Answer: underground
Page 2