Sawblade Certificate Study Material - Comprehensive Answer Key

Sawblade Certificate Study Material - Comprehensive Answer Key What are calipers used to measure? - answer - Internal, external, and depth measurements What should the reading be on a properly calibrated caliper when the jaws are touching? - answer - 0.000 Which of the following is the best tool for squaring a line across a board? - answer - Try Square What tool would be used to lay out a 35 degree angle? - answer - sliding T-bevel Which of the following is a consideration before attempting to rip on a Table Saw? - answer - Stock is supported at out-feed A dado head cannot cut: - answer - Mortises Ripping narrow stock on the table saw requires: - answer - a splitter or riving knife, guard, fence, and push stick The size of a table saw is determined by the: - answer - blade diameter When using dado cutters on the table saw, the table insert must be replaced with a special: - answer - throat plate The blade guard on a band saw should be adjusted ________. - answer - to within 1/4" of the stock What is the dimension tolerance for Freehand Ripping One Edge on the Band Saw? - answer - 1/16" A __________ is used for re-sawing on a band saw. - answer - pivot block Describe where the saw guides are located on a band saw: - answer - Both sides and behind the blade, above and below the table The __________ is located behind the blade and prevents the blade from deflecting when the stock is pushed into the blade. - answer - thrust bearing Which of the following is a consideration before milling a board on the jointer? - answer - Grain direction as well as bow/warp are correctly identified To get a 1/16" depth and a 3 degree bevel using the jointer, what needs to be adjusted? - answer - infeed table and fence What part of a jointer is kept in a fixed height position for all standard operations? - answer - outfeed table Jointing against the grain of a board will most likely result in ________. - answer - chipped grains When milling rough sawn boards on a single-sided Planer or Surfacer, the machine _______. - answer - will not remove a warp from a board Warp in solid stock is removed by a: - answer - jointer Which of the following is a consideration before milling a board on a Planer? - answer - The lower feed rolls on the planer can be set higher to - answer - improve the ability to feed Which of the following is a consideration when using a Portable Router? - answer - Router bit pointed away from body after completion of cut Changing router bits must only take place when the ____________. - answer - router is unplugged from the power outlet What is the dimension tolerance for a Rabbet milled with a Portable Router? - answer - 1/64" if one needed a rabbet on a board and had a straight bit in the router, which of the following statements would be correct? - answer - A straight fence with a cut-out for the bit is needed When giving the size of a board, we give the size in a specific sequence; which sequence below is in the correct order? - answer - thickness, width, length The function of a pilot or bearing on a router bit is to ___________. - answer - follow a contour Random Orbit sanders tend to leave _________. - answer - circular scratches on the wood which of the following is not used for sand paper? - answer - pearlite Which of the following is a Level 1 performance standard for Portable Hand Sanders on solid wood parts? - answer - No apparent round over edges The best general grade of hardwoods would be: - answer - FAS Which of the following is the least dimensionally stable - answer - solid oak Hardwood should typically be dried to what moisture content before working with it? - answer - 6-8% What is the footage of a 5/4" x 12" x 96" board? - answer - 10 The standard size of plywood in the U.S. is: - answer - 48" x 96" What machine will best make 1 edge and 1 surface square clean? - answer - jointer What machine is used to make two surfaces parallel? - answer - planer Plain or Flat sawn woods e