MSSC Quality Practice test
Question 1.
What are the two types of assembly drawings?
ANSWER
Exploded and basic
Question 2.
The three standard views of an object are ____________
ANSWER
top, front, right side
Question 3.
Geometric dimensioning and tolerances refers to tolerances which control
ANSWER
Form, profile, orientation, location, and runout
Question 4.
Which type of feature is parallel to the surface being dimensioned?
ANSWER
dimension lines
Question 5.
To establish on a drawing that 1/8 inch equals 1 inch, the designer would write ____________.
ANSWER
1/8 = 1
Question 6.
If the feature on the drawing is drawn 2 inched long and the scale is 1:4, what is the actual dimension of the object?
ANSWER
8"
Question 7.
If a box of parts weighs 30 pounds, how many kilograms does it weigh?
ANSWER
13.6 kilograms
, Question 8.
The acronym, ECN, stands for:
ANSWER
Engineering Change Notice
Question 9.
A capable manufacturing process tends to run
ANSWER
out of control
Question 10.
The acronym, SPC, stands for
ANSWER
Statistical process control
Question 11.
Adjustments in follow-up with product quality checks are necessary in a/an _______ non-conformity
ANSWER
Product process and system
Question 12.
Recommendations for corrective action are the re-sponsibility of
ANSWER
All knowledgeable persons
Question 13.
To convert inches to millimeters, multiply inches by:
ANSWER
25.4
Question 14.
Identify a device that measures length to an accuracy of 0.001 inch.
ANSWER
Micrometer
Question 15.
A ________ is the total amount by which a specified dimension is allowed to vary and still be a good part
ANSWER
tolerance
Question 1.
What are the two types of assembly drawings?
ANSWER
Exploded and basic
Question 2.
The three standard views of an object are ____________
ANSWER
top, front, right side
Question 3.
Geometric dimensioning and tolerances refers to tolerances which control
ANSWER
Form, profile, orientation, location, and runout
Question 4.
Which type of feature is parallel to the surface being dimensioned?
ANSWER
dimension lines
Question 5.
To establish on a drawing that 1/8 inch equals 1 inch, the designer would write ____________.
ANSWER
1/8 = 1
Question 6.
If the feature on the drawing is drawn 2 inched long and the scale is 1:4, what is the actual dimension of the object?
ANSWER
8"
Question 7.
If a box of parts weighs 30 pounds, how many kilograms does it weigh?
ANSWER
13.6 kilograms
, Question 8.
The acronym, ECN, stands for:
ANSWER
Engineering Change Notice
Question 9.
A capable manufacturing process tends to run
ANSWER
out of control
Question 10.
The acronym, SPC, stands for
ANSWER
Statistical process control
Question 11.
Adjustments in follow-up with product quality checks are necessary in a/an _______ non-conformity
ANSWER
Product process and system
Question 12.
Recommendations for corrective action are the re-sponsibility of
ANSWER
All knowledgeable persons
Question 13.
To convert inches to millimeters, multiply inches by:
ANSWER
25.4
Question 14.
Identify a device that measures length to an accuracy of 0.001 inch.
ANSWER
Micrometer
Question 15.
A ________ is the total amount by which a specified dimension is allowed to vary and still be a good part
ANSWER
tolerance
