• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 4 fuera de 37 páginas
Examen

Exam_Elaborations_Irc_Building_Code_Final_Paper_2026_Test_Paper.pdf

Document preview thumbnail
Vista previa 4 fuera de 37 páginas

Exam_Elaborations_Irc_Building_Code_Final_Paper_2026_Test_P

Vista previa del contenido

EXAM ELABORATIONS IRC
BUILDING UPDATED QUESTIONS
WITH CORRECT ANSWERS

◉ When the header joist span does not exceed ____ feet, the header
joist may be a single member the same size as the floor joist.
Answer: 4 ft.
(When the header joist span exceeds 4 feet the trimmer joists and
header joists shall be doubled)


R502.10 Framing of openings


◉ In combustible construction, where there is usable space both
above and below a floor/ceiling assembly, draft stops shall be
installed so that the area of the concealed space does not exceed ____
square feet. Answer: 1000 sq. ft.
(Draft-stopping shall divide the concealed space into approximately
equal areas.


R302.12 Draft-stopping


◉ The provisions of Section R505 Steel Floor Framing shall control
the construction of cold-formed steel floor framing for building not

,greater than ____ feet in length perpendicular to the joist span.
Answer: 60 ft.
(Read this section for more applicability limits).


R505.1.1 Applicability limits


◉ Flanges and lips of load-bearing cold-formed steel floor framing
members shall not be cut or ____. Answer: Notched


R505.3.5


◉ In cold-formed steel framing, floor cantilevers for the top floor of
a two- or three-story building or the first floor of a one-story
buidling shall not exceed ____. Answer: 24 in.


R505.3.6 Floor cantilevers


◉ Concrete slab-on-ground floors shall be a minimum of ____ inches
thick. Answer: 3.5 in.


R506.1 General

,◉ The connection between a deck ledger and a 2-inch nominal
lumber band joist shall be constructed with ____-inch lag screws or
bolts with washers. Answer: 1/2 in.
(In accordance with Table R507.2. See figures R507.2.1(1) and
R507.2.1(2)


R507.2 Deck ledger connection to band joist.


◉ For wood stud walls, end joints in top plates shall be offset at least
____ inches. Answer: 24 in.


R602.3.2 Top plate


◉ When joists, trusses or rafters are spaced more than 16 inches on
center and the bearing studs below are spaced 24 inches on center,
such members shall bear within ____ inches of the studs beneath.
Answer: 5 in.
(Read 3 exceptions in this section)


R602.3.3 Bearing studs


◉ Any wood stud in an exterior wall or bearing partition may be cut
or notched to a depth not exceeding ____ percent of its width.
Answer: 25%

, R602.6 Drilling and notching studs #1


◉ Wood studs in non bearing partitions may be notched to a depth
not exceeding ____ percent of a single stud width. Answer: 40%


R602.6 Drilling and notching studs #1


◉ Exterior wood frame walls shall be offset not more than ___ feet
from the designated braced wall line location. Answer: 4 ft.
(See figure R602.10.1.1)


R602.10.1.2 Offsets along a braced wall line.


◉ Braced wall lines greater than 16 feet shall have a minimum of ____
braced wall panels. Answer: two


R602.10.2.3 Minimum number of braced wall panels.


◉ Wall bracing Method PFG (Portal frame at garage door openings)
is limited to walls supporting ____ ____ and a _____. Answer: One story
Roof
(This method is also limited to Seismic Design Categories A, B and C.

Información del documento

Subido en
15 de octubre de 2026
Número de páginas
37
Escrito en
2026/2027
Tipo
Examen
Contiene
Preguntas y respuestas
$16.49

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Vendido
4
Seguidores
0
Artículos
8342
Última venta
1 semana hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes