Bfm Questions With Accurate Answers

BFM QUESTIONS WITH ACCURATE ANSWERS
_____ aircraft is responsible for collision avoidance. correct answer Up-sun


3K DEFENSIVE STUDENT COMMS, "Fox-2," COMM: _____. correct answer "Break
L/R" (ICS), "Flares" (PRI)," executing a break turn into the bandit.


6K DEFENSIVE STUDENT COMMS, "Fox-2," COMM: _____. correct answer "Break
L/R" (ICS), "Flares" (PRI)," executing a break turn into the bandit.


9K DEFENSIVE STUDENT COMMS, "Fox-2," COMM: _____. correct answer "Break
L/R" (ICS), "Flares" (PRI)," executing a break turn into the bandit.


A _____ _____ is an offensive, lag pursuit maneuver designed to prevent an
overshoot by controlling excessive closure while preserving range. correct answer
High yo-yo


A _____ overshoot occurs when an attacker accidentally flies from a position aft
of the defender's 3/9 line to a position forward of it, it results in an immediate
_____ _____. correct answer 3/9-line overshoot, role reversal


A _____-_____ overshoot occurs when the attacker flies through the defender's
flight path. A role reversal in this case is not guaranteed. correct answer flight-
path overshoot


A "_____" call is required prior to each engagement. correct answer "Speed and
angels" call

,A key factor in winning the rolling scissors fight is the ability of one aircraft to get
its nose up when at the bottom of a roller before the opponent can get their nose
down at the top, utilizing the geometry from the tactical _____. correct answer
egg


Above corner, the _____ limit cannot be reached, and "_____" (turning wider
than optimum) occurs. correct answer lift limit cannot be reached, arcing occurs


Above corner, the best turn performance realized is at the _____ limit. correct
answer G limit


Adhering to the 10 percent rule for deck awareness provides a smooth deck
transition with a high _____ package. correct answer high energy package


After the merge, if both aircraft turn towards the same direction, it is said to be
"one circle" because both aircraft are turning around the same relative _____ to
create a single circle. correct answer Post


All aircraft must maintain _____ feet of separation between all aircraft, at all
times. correct answer 500 feet


An _____-_____ overshoot occurs when the attacker crosses the defender's flight
path inside the control zone. This overshoot is significant because an
instantaneous reversal by the defender could result in a 3/9-line overshoot and a
role reversal. correct answer in-close


Angles is usually defined as _____ _____ _____, where 0 degrees is off the
defender's tail (six o'clock position), and, for example, directly abeam is 90
degrees. correct answer angle off tail

, As a rule of thumb for max G available in a given flight regime, _____ G is lost for
every 50 KIAS below corner airspeed. correct answer 1 G


As an aircraft operates at its lift limit, and continues to "max perform," airspeed
and turn performance will _____ as it follows the lift limit curve to the left. correct
answer decay


As the attacker rolls to pull his nose down (cracking his wings) out of the high yo-
yo, transitioning to a low yo-yo, defensive student will call "lift vector on." Prior to
the attacker reaching the horizon, the defending student should call "_____-
_____, left/right" to offset the attacker's energy gain in his nose-low attitude.
correct answer "nose-low, left/right"


As the shooter approaches the snapshot envelope, the target student will call for
"_____ _____." The target IP will then put a wingtip on the attacker and
maneuver _____ _____ _____ in an attempt to defeat the snapshot. correct
answer "Guns D," out of plane


At 250 KIAS, max G available is _____ G. correct answer 3.5 G


At 350 KIAS, max G available is _____ G. correct answer 5.5 G


At 410 KIAS (cornering airspeed), max G available is _____ G. correct answer 6.5 G


At any airspeed below corner, pulling more than _____ units AOA will induce an
accelerated stall. correct answer 24 units AOA