CONSTRUCTION COORDINATOR
CERTIFICATION EVALUATION QUESTIONS
AND SOLUTIONS GRADED A+
●● When backfilling a boring pit or trench what should be done to
protect the buried conduit or cable in conduit (CIC)?
Answer: Remove accessible rocks and backfill all but the top 12 inches
of the pit or trench with sand
●● When using a fluid-assisted boring machine, why is the drilling fluid
added when pulling the drill string back through the hole?
Answer: To help the rotating back-reamer expand the drilled pilot hole
diameter and reduce the drag on the conduit that is being pulled into
place
●● When must all fluid assisted boring machine operators and crew
members do in case of an inadvertent utility cut or other unforseen
accident?
Answer: Follow a company and equipment manufacturer guidelines and
safety procedures
●● What do electrical grid mats that are bonded to a fluid assisted
boring system provide?
,Answer: Operator protection in case of contact with electrical lines the
boring equipment and machine operators are at the same electrical
potential
●● Which type of vibratory plow is an attachment to a tractor or
trenches and requires a ground person to manually guide the conduit into
the feed chute as the plow cuts through the ground?
Answer: The Modular Vibratory Plow
●● In which areas is the use of a Vibratory plow much more economical
than trenching?
Answer: In underdeveloped areas where a large tractor can be
maneuvered
●● How can coaxial cable be plowed using a plow machine without a
cable reel carrier?
Answer: Lay the coaxial cable along the bury route and have a helper
guide the coaxial cable into the feed chute of the forwarding plow
●● When preparing to plow conduit how long should the starter trench
be?
Answer: A length that allows the plow blade to be lowered to the burial
depth without violating the minimum bend radius of the attached conduit
, ●● When using a surface dry boring machine what is the preferred
forward speed of the machine?
Answer: A speed that allows a boring bit to work freely without being
forced
●● What is the purpose of a portable conduit fishing system?
Answer: It is used to blow a pull line through the conduit
●● How much contraction will 1200ft of conduit have if the temp
changes from 94F to 54F when the rate of contraction is 1 1/2 in per
100ft per 20F change?
Answer: 36 inches
●● When directly burying coaxial cable,
Answer: Avoid reverse bending of the coaxial cable when unreeling the
coaxial cable
●● What is the proper method for removing the coaxial cable from its
reel for a direct burial operation?
Answer: With the reel on an appropriate stand pull the cable from the
bottom of the reel
●● What may be required to remove a large rock from the ground during
trenching?
CERTIFICATION EVALUATION QUESTIONS
AND SOLUTIONS GRADED A+
●● When backfilling a boring pit or trench what should be done to
protect the buried conduit or cable in conduit (CIC)?
Answer: Remove accessible rocks and backfill all but the top 12 inches
of the pit or trench with sand
●● When using a fluid-assisted boring machine, why is the drilling fluid
added when pulling the drill string back through the hole?
Answer: To help the rotating back-reamer expand the drilled pilot hole
diameter and reduce the drag on the conduit that is being pulled into
place
●● When must all fluid assisted boring machine operators and crew
members do in case of an inadvertent utility cut or other unforseen
accident?
Answer: Follow a company and equipment manufacturer guidelines and
safety procedures
●● What do electrical grid mats that are bonded to a fluid assisted
boring system provide?
,Answer: Operator protection in case of contact with electrical lines the
boring equipment and machine operators are at the same electrical
potential
●● Which type of vibratory plow is an attachment to a tractor or
trenches and requires a ground person to manually guide the conduit into
the feed chute as the plow cuts through the ground?
Answer: The Modular Vibratory Plow
●● In which areas is the use of a Vibratory plow much more economical
than trenching?
Answer: In underdeveloped areas where a large tractor can be
maneuvered
●● How can coaxial cable be plowed using a plow machine without a
cable reel carrier?
Answer: Lay the coaxial cable along the bury route and have a helper
guide the coaxial cable into the feed chute of the forwarding plow
●● When preparing to plow conduit how long should the starter trench
be?
Answer: A length that allows the plow blade to be lowered to the burial
depth without violating the minimum bend radius of the attached conduit
, ●● When using a surface dry boring machine what is the preferred
forward speed of the machine?
Answer: A speed that allows a boring bit to work freely without being
forced
●● What is the purpose of a portable conduit fishing system?
Answer: It is used to blow a pull line through the conduit
●● How much contraction will 1200ft of conduit have if the temp
changes from 94F to 54F when the rate of contraction is 1 1/2 in per
100ft per 20F change?
Answer: 36 inches
●● When directly burying coaxial cable,
Answer: Avoid reverse bending of the coaxial cable when unreeling the
coaxial cable
●● What is the proper method for removing the coaxial cable from its
reel for a direct burial operation?
Answer: With the reel on an appropriate stand pull the cable from the
bottom of the reel
●● What may be required to remove a large rock from the ground during
trenching?