1|Page
EVITP FINAL EXAM| COMPREHENSIVE
Q&A FOR CERTIFICATION SUCCESS 2026
Later in the development of EV charging equipment, the actual charging means
was accomplished by a(n) ? that converts AC to DC to be used in charging the
vehicle's battery.
Select one:
a.internal combustion generator
b.inverter
c.rectifier
d.voltage source - correct-answer - c.rectifier
Electric vehicle supply equipment (EVSE) provides which of the following safety
features?
Select one:
a.A continuously energized output
b.GFCI protection
,2|Page
c.Hardware fault detection
d.Both b. and c. - correct-answer - d.Both b. and c.
EVSE provides DC power to the electric vehicle charging port.
Select one:
True
False - correct-answer - False
DC charging equipment provides DC directly to ? in an EV.
Select one:
a.battery management systems
b.battery monitoring devices
c.charge multiplier systems
d.current management systems - correct-answer - a.battery management
systems
,3|Page
An AC charger with a single-phase 120-volt connection and 14-16 amperes of
continuous current output is classified as a ? charger.
Select one:
a.Level 1
b.Level 2
c.low-voltage
d.SAE standard - correct-answer - a.Level 1
The purpose of the J1772 connector pins is to provide ? .
Select one:
a.a charging interface that is safe for consumers to use
b.a means to signal the EVSE to stop charging based on the pin contact state
c.signals to the EVSE that the connector is properly seated on the vehicle
d.all of the above - correct-answer - d.all of the above
Which of the following is true about the J1772 standard control pilot terminal
pin's function?
, 4|Page
Select one:
a.It changes the state of the EVSE according to the voltage present.
b.It defines the state of the EVSE.
c.It uses a +12V to -12V AC square wave signal.
d.All of the above - correct-answer - d.All of the above
Which of the following is not a variable that determines the charging time of an
EV?
a.Connector configuration
b.Max power capacity of the EV's converter
c.Size of the electrical feeder/service supplying the EVSE
d.All of the above - correct-answer - a.Connector configuration
The EV's power acceptance rate should not be considered when making EVSE
purchasing decisions.
Select one:
True
EVITP FINAL EXAM| COMPREHENSIVE
Q&A FOR CERTIFICATION SUCCESS 2026
Later in the development of EV charging equipment, the actual charging means
was accomplished by a(n) ? that converts AC to DC to be used in charging the
vehicle's battery.
Select one:
a.internal combustion generator
b.inverter
c.rectifier
d.voltage source - correct-answer - c.rectifier
Electric vehicle supply equipment (EVSE) provides which of the following safety
features?
Select one:
a.A continuously energized output
b.GFCI protection
,2|Page
c.Hardware fault detection
d.Both b. and c. - correct-answer - d.Both b. and c.
EVSE provides DC power to the electric vehicle charging port.
Select one:
True
False - correct-answer - False
DC charging equipment provides DC directly to ? in an EV.
Select one:
a.battery management systems
b.battery monitoring devices
c.charge multiplier systems
d.current management systems - correct-answer - a.battery management
systems
,3|Page
An AC charger with a single-phase 120-volt connection and 14-16 amperes of
continuous current output is classified as a ? charger.
Select one:
a.Level 1
b.Level 2
c.low-voltage
d.SAE standard - correct-answer - a.Level 1
The purpose of the J1772 connector pins is to provide ? .
Select one:
a.a charging interface that is safe for consumers to use
b.a means to signal the EVSE to stop charging based on the pin contact state
c.signals to the EVSE that the connector is properly seated on the vehicle
d.all of the above - correct-answer - d.all of the above
Which of the following is true about the J1772 standard control pilot terminal
pin's function?
, 4|Page
Select one:
a.It changes the state of the EVSE according to the voltage present.
b.It defines the state of the EVSE.
c.It uses a +12V to -12V AC square wave signal.
d.All of the above - correct-answer - d.All of the above
Which of the following is not a variable that determines the charging time of an
EV?
a.Connector configuration
b.Max power capacity of the EV's converter
c.Size of the electrical feeder/service supplying the EVSE
d.All of the above - correct-answer - a.Connector configuration
The EV's power acceptance rate should not be considered when making EVSE
purchasing decisions.
Select one:
True
