NACE CIP1 EXAM ACTUAL
EXAM 2026 | ALL
QUESTIONS AND CORRECT
ANSWERS | VERIFIED
ANSWERS | UPDATED
VERSION
Terms in this set (97)
,What is the first preferred Document the problem and advise
course of action if small the Contractor and Owner's
blisters are noticed in a tank representative.
lining?
What is dew point? The temperature at which
condensation occurs.
What should a coating A blotter test for the presence of oil
inspector perform if a and water.
poorly maintained
compressor is used?
What should an inspector Observe and document the amount of
do upon arrival of coating material and batch numbers.
materials?
What is relative humidity? A measure of the amount of moisture
in the air compared to saturation level.
, Galvanic corrosion occurs Metal.
on which substrate?
Which specification is most SSPC-CS 23.00/AWS C2.23/NACE No.
likely referenced when 12.
applying Thermal Spray
Coatings?
What is the minimum 2.5 cm (1 inch).
recommended distance for
taking a DFT gauge
measurement from an
edge?
What is polymerization? The process of monomers joining
together.
EXAM 2026 | ALL
QUESTIONS AND CORRECT
ANSWERS | VERIFIED
ANSWERS | UPDATED
VERSION
Terms in this set (97)
,What is the first preferred Document the problem and advise
course of action if small the Contractor and Owner's
blisters are noticed in a tank representative.
lining?
What is dew point? The temperature at which
condensation occurs.
What should a coating A blotter test for the presence of oil
inspector perform if a and water.
poorly maintained
compressor is used?
What should an inspector Observe and document the amount of
do upon arrival of coating material and batch numbers.
materials?
What is relative humidity? A measure of the amount of moisture
in the air compared to saturation level.
, Galvanic corrosion occurs Metal.
on which substrate?
Which specification is most SSPC-CS 23.00/AWS C2.23/NACE No.
likely referenced when 12.
applying Thermal Spray
Coatings?
What is the minimum 2.5 cm (1 inch).
recommended distance for
taking a DFT gauge
measurement from an
edge?
What is polymerization? The process of monomers joining
together.
