NYC MASTER ELECTRICIAN
Exam Study Guide – Practice
Questions with Verified
Answers. GRADED A+. Latest
2026/2027 Update
Type ____ is multiconductor cable identified for use as underground service
entrance cable. - Answer✔✔-Type USE cable
Knife switch rated for more than 1200 Amps at 250Volts or less - Answer✔✔-
Can be used only as isolating switch, shall not be opened under load
Track lighting with outlets in a bathroom is not allowed because ? -
Answer✔✔-Track lighting has receptacle
Where internal combustion engines are used as the prime motor, an on site
fuel supply shall be provided with an on premise fuel supply sufficient for not
less than ____ hours full demand operation of the system - Answer✔✔-6 hours
Fixed in place X-ray equipment properly supplied by a branch circuit rated at
not over ____ amperes shall be permitted to be supplied through a suitable
attachment plug cap and hard service cable cord. - Answer✔✔-30 Amps
,Where skin effect exist the ferromagnetic envelope shall be bonded at ____. -
Answer✔✔-Both ends
GFCI protection at a carnival is not required for equipment at circuit if the
receptacle is of the ____type. - Answer✔✔-Locking
The maximum voltage drop from service point to the last over-current device in
a dwelling unit? - Answer✔✔-4%
Which of the following statements best describe the grounding requirement for
central vacuum outlet - Answer✔✔-Accessible non current carrying metal
parts are required to be connected to an equipment grounding conductor.
In healthcare facilities, patient bed receptacles located in general care areas
shall be supplied by at least two branch circuits, which ____permitted to
originate from two separate transfer switches on the emergency system -
Answer✔✔-Are permitted
Patient care areas of healthcare facilities ____ areas such as business offices,
corridors, lounges ,day rooms, or similar areas - Answer✔✔-Do not include
The patient care area is any portion of the healthcare facility where patients
are intended to be ____or ____. - Answer✔✔-Examined or treated
Each general care area patient bed location in a healthcare facility must be
provided with four ____ or ____ duplex receptacles - Answer✔✔-Single or two
,A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or more
patients - Answer✔✔-Four
Where installed to reduce electrical noise for electronic equipment, electrical
continuity of the metal raceways shall not be required and metal raceway can
terminate a (an) ____ nonmetallic fitting or spacer on electronic equipment -
Answer✔✔-Listed fitting
Feeder and branch circuit conductors within ____ inches of a Ballast shall have
an insulation temperature rating not lower than 90°C (194°F) unless supplying
a luminaiere marked as suitable for a different insulation temperature -
Answer✔✔-3 inches
Manufactured wiring systems constructed with type MC cable shall be
supported and secured at intervals not exceeding ____ ft. - Answer✔✔-6 ft
Where a main bonding jumper or a system bonding jumper is a screw only the
screw shall be identified with a ____ that shall be visible with the screw
installed - Answer✔✔-Green finish
Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish them
from fuses of higher ampere rating - Answer✔✔-Hexagon
The load for household electric clothes dryer's in a dwelling unit(s) shall be
either ____ watts (volt-amperes) or the nameplate rating, which ever is larger,
for each dryer served ? - Answer✔✔-5000 watts
, Service conductors installed as unjacketed multiconductor cable shall have a
minimum clearance of ____ windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations. - Answer✔✔-3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be permitted to be used only
for replacement in existing installation is where there is no evidence of over-
fusing or tampering. - Answer✔✔-Class H
Branch circuit conductors within ____inches of the ballast shall have an
insulation temperature rating not lower it 90°C 194°F - Answer✔✔-3" inches
The minimum radius of a field bend on trade size 1 "1/4 RMC is ____. -
Answer✔✔-8
In a dwelling unit which appliance is allowed to have a 24"inch cord with
Attachment ground plug ? - Answer✔✔-Combination range hood/microwave
oven
Type 3 Surge Protective devices can be installed on the load side of a branch
circuit overcurrent device up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a distance from the service
or separately derived system disconnect - Answer✔✔-Included in the
manufactures instructions
Which flexible cable is Allowed to be used for electric vehicle charging station
300 Volts ? - Answer✔✔-EVJ
Exam Study Guide – Practice
Questions with Verified
Answers. GRADED A+. Latest
2026/2027 Update
Type ____ is multiconductor cable identified for use as underground service
entrance cable. - Answer✔✔-Type USE cable
Knife switch rated for more than 1200 Amps at 250Volts or less - Answer✔✔-
Can be used only as isolating switch, shall not be opened under load
Track lighting with outlets in a bathroom is not allowed because ? -
Answer✔✔-Track lighting has receptacle
Where internal combustion engines are used as the prime motor, an on site
fuel supply shall be provided with an on premise fuel supply sufficient for not
less than ____ hours full demand operation of the system - Answer✔✔-6 hours
Fixed in place X-ray equipment properly supplied by a branch circuit rated at
not over ____ amperes shall be permitted to be supplied through a suitable
attachment plug cap and hard service cable cord. - Answer✔✔-30 Amps
,Where skin effect exist the ferromagnetic envelope shall be bonded at ____. -
Answer✔✔-Both ends
GFCI protection at a carnival is not required for equipment at circuit if the
receptacle is of the ____type. - Answer✔✔-Locking
The maximum voltage drop from service point to the last over-current device in
a dwelling unit? - Answer✔✔-4%
Which of the following statements best describe the grounding requirement for
central vacuum outlet - Answer✔✔-Accessible non current carrying metal
parts are required to be connected to an equipment grounding conductor.
In healthcare facilities, patient bed receptacles located in general care areas
shall be supplied by at least two branch circuits, which ____permitted to
originate from two separate transfer switches on the emergency system -
Answer✔✔-Are permitted
Patient care areas of healthcare facilities ____ areas such as business offices,
corridors, lounges ,day rooms, or similar areas - Answer✔✔-Do not include
The patient care area is any portion of the healthcare facility where patients
are intended to be ____or ____. - Answer✔✔-Examined or treated
Each general care area patient bed location in a healthcare facility must be
provided with four ____ or ____ duplex receptacles - Answer✔✔-Single or two
,A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or more
patients - Answer✔✔-Four
Where installed to reduce electrical noise for electronic equipment, electrical
continuity of the metal raceways shall not be required and metal raceway can
terminate a (an) ____ nonmetallic fitting or spacer on electronic equipment -
Answer✔✔-Listed fitting
Feeder and branch circuit conductors within ____ inches of a Ballast shall have
an insulation temperature rating not lower than 90°C (194°F) unless supplying
a luminaiere marked as suitable for a different insulation temperature -
Answer✔✔-3 inches
Manufactured wiring systems constructed with type MC cable shall be
supported and secured at intervals not exceeding ____ ft. - Answer✔✔-6 ft
Where a main bonding jumper or a system bonding jumper is a screw only the
screw shall be identified with a ____ that shall be visible with the screw
installed - Answer✔✔-Green finish
Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish them
from fuses of higher ampere rating - Answer✔✔-Hexagon
The load for household electric clothes dryer's in a dwelling unit(s) shall be
either ____ watts (volt-amperes) or the nameplate rating, which ever is larger,
for each dryer served ? - Answer✔✔-5000 watts
, Service conductors installed as unjacketed multiconductor cable shall have a
minimum clearance of ____ windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations. - Answer✔✔-3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be permitted to be used only
for replacement in existing installation is where there is no evidence of over-
fusing or tampering. - Answer✔✔-Class H
Branch circuit conductors within ____inches of the ballast shall have an
insulation temperature rating not lower it 90°C 194°F - Answer✔✔-3" inches
The minimum radius of a field bend on trade size 1 "1/4 RMC is ____. -
Answer✔✔-8
In a dwelling unit which appliance is allowed to have a 24"inch cord with
Attachment ground plug ? - Answer✔✔-Combination range hood/microwave
oven
Type 3 Surge Protective devices can be installed on the load side of a branch
circuit overcurrent device up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a distance from the service
or separately derived system disconnect - Answer✔✔-Included in the
manufactures instructions
Which flexible cable is Allowed to be used for electric vehicle charging station
300 Volts ? - Answer✔✔-EVJ
