IRONWORKER NCCER EXAM |
COMPLETE ACCURATE CURRENTLY
TESTING REAL EXAM QUESTIONS WITH
DETAILED ANSWERS LATEST EXAM
What should always be used to ignite a cutting torch? - ✔✔✔ correct
answer > striker
Equalizing the weight of the load at various lifting points is called: -
✔✔✔ correct answer > configuration
A combination square without a protractor head is used to layout: -
✔✔✔ correct answer > 45 degree lines
Prior to inspection it is good practice to test all studs with what method?
- ✔✔✔ correct answer > ping test
,Where is the fulcrum or pivot point on a forklift? - ✔✔✔ correct
answer > the front axle
A document that outlines weights, crane configuration and rigging
requirements for a lift is called an: - ✔✔✔ correct answer > lift plan
Where can the bolting methods regarding structural steel usually be
found? - ✔✔✔ correct answer > in the general notes of the structural
drawings
When establishing elevations of structural steel members, the reference
point used to determine all other elevations is called? - ✔✔✔ correct
answer > the benchmark
What is the surface area of a rectangle with the dimensions of 30'6" tall
and 6 feet wide? - ✔✔✔ correct answer > 183ft
, Measurements from the center of the cranes axis of rotation to the center
of the load line with the load applied is: - ✔✔✔ correct answer > load
radius
Which of the following tools would be used to pry steel into place? -
✔✔✔ correct answer > sleever bar
When traveling to pick up a load always keep the: - ✔✔✔ correct
answer > forks low
What is a GFCI? - ✔✔✔ correct answer > ground fault circuit
interrupter
A critical lift plan includes all of the following information except: -
✔✔✔ correct answer > the number of supervisors
COMPLETE ACCURATE CURRENTLY
TESTING REAL EXAM QUESTIONS WITH
DETAILED ANSWERS LATEST EXAM
What should always be used to ignite a cutting torch? - ✔✔✔ correct
answer > striker
Equalizing the weight of the load at various lifting points is called: -
✔✔✔ correct answer > configuration
A combination square without a protractor head is used to layout: -
✔✔✔ correct answer > 45 degree lines
Prior to inspection it is good practice to test all studs with what method?
- ✔✔✔ correct answer > ping test
,Where is the fulcrum or pivot point on a forklift? - ✔✔✔ correct
answer > the front axle
A document that outlines weights, crane configuration and rigging
requirements for a lift is called an: - ✔✔✔ correct answer > lift plan
Where can the bolting methods regarding structural steel usually be
found? - ✔✔✔ correct answer > in the general notes of the structural
drawings
When establishing elevations of structural steel members, the reference
point used to determine all other elevations is called? - ✔✔✔ correct
answer > the benchmark
What is the surface area of a rectangle with the dimensions of 30'6" tall
and 6 feet wide? - ✔✔✔ correct answer > 183ft
, Measurements from the center of the cranes axis of rotation to the center
of the load line with the load applied is: - ✔✔✔ correct answer > load
radius
Which of the following tools would be used to pry steel into place? -
✔✔✔ correct answer > sleever bar
When traveling to pick up a load always keep the: - ✔✔✔ correct
answer > forks low
What is a GFCI? - ✔✔✔ correct answer > ground fault circuit
interrupter
A critical lift plan includes all of the following information except: -
✔✔✔ correct answer > the number of supervisors
