Florida Unlimited Electrical Contractor
Exam (NEC) standards 2026 Test
1. When ropes are used to define control access areas the C. 200
rope shall have a minimum breaking strength of
pounds.
A. 75
B. 100
C. 200
D. 300
2. What is the weight in pounds per square foot of 22 C. 1.22
gauge sheet metal?
A. 1.95
B. 1.47
C. 1.22
D. 0.98
3. Laws have been passed in many municipalities which A. 90%
require transformers to high voltage transformer in-
stallations to maintain a power factor of or better.
A. 90%
B. 85%
C. 80%
D. 75%
4. Per the Americans with Disabilities Act, are pro- A. Pre-employment med-
hibited, with the exceptions of inquires of an appli- ical tests
cant's ability to perform job-related functions.
A. Pre-employment medical tests
B. Bans on smoking
, Florida Unlimited Electrical Contractor
Exam (NEC) standards 2026 Test
C. Subcontractors and employees
D. Works of any type over age 18
5. New sign placement for access to exits shall be such B. 100
that no point in an exit access corridor is in excess of
the rated viewing distance or ft., whichever is less,
from the nearest sign.
A. 75
B. 100
C. 150
D. 200
6. Barricades for protection of employees shall D. Conform to the Manual
of Uniform Traflc Control
A. Be approved by OSHA Devices
B. Be constructed of wood laminated framing and con-
form to 489.134
C. Be constructed of laminated steel and conform to
489.134
D. Conform to the Manual of Uniform Traffic Control
Devices
7. The minimum illumination of means of egress along A. 0.2
the required means of egress path in an occupied
building shall be ft-candle.
A. 0.2
B. 1
C. 1 1/2
D. 2 1/2
8. A. 18
, Florida Unlimited Electrical Contractor
Exam (NEC) standards 2026 Test
The entire area of an aircraft maintenance and stor-
age hangar, including an adjacent and communicating
areas not suitably cut off from the hangar, shall be
classified as a Class I, Division 2 or Zone 2 location up
to a level of inches above the floor.
A. 18
B. 24
C. 12
D. 30
9. The only calculable forces that socket-to-support B. Sign cabinet
welds must carry is the weight of the ?
A. Truss
B. Sign cabinet
C. Loads acting in only one direction
D. Wind load and weight of frame
10. A hand-held grinder with a 2-1/8" diameter wheel shall B. Momentary contact
be equipped with only a: on/ott switch
A. Constant pressure switch
B. Momentary contact on/off switch
C. Positive percussion switch
D. Positive on/off switch
11. In health care facilities, essential electrical systems B. Of two independent
shall have a MINIMUM . sources of power
A. Capacity of 200 gallons of fuel for the auxiliary gen-
erator
B. Of two independent sources of power
Exam (NEC) standards 2026 Test
1. When ropes are used to define control access areas the C. 200
rope shall have a minimum breaking strength of
pounds.
A. 75
B. 100
C. 200
D. 300
2. What is the weight in pounds per square foot of 22 C. 1.22
gauge sheet metal?
A. 1.95
B. 1.47
C. 1.22
D. 0.98
3. Laws have been passed in many municipalities which A. 90%
require transformers to high voltage transformer in-
stallations to maintain a power factor of or better.
A. 90%
B. 85%
C. 80%
D. 75%
4. Per the Americans with Disabilities Act, are pro- A. Pre-employment med-
hibited, with the exceptions of inquires of an appli- ical tests
cant's ability to perform job-related functions.
A. Pre-employment medical tests
B. Bans on smoking
, Florida Unlimited Electrical Contractor
Exam (NEC) standards 2026 Test
C. Subcontractors and employees
D. Works of any type over age 18
5. New sign placement for access to exits shall be such B. 100
that no point in an exit access corridor is in excess of
the rated viewing distance or ft., whichever is less,
from the nearest sign.
A. 75
B. 100
C. 150
D. 200
6. Barricades for protection of employees shall D. Conform to the Manual
of Uniform Traflc Control
A. Be approved by OSHA Devices
B. Be constructed of wood laminated framing and con-
form to 489.134
C. Be constructed of laminated steel and conform to
489.134
D. Conform to the Manual of Uniform Traffic Control
Devices
7. The minimum illumination of means of egress along A. 0.2
the required means of egress path in an occupied
building shall be ft-candle.
A. 0.2
B. 1
C. 1 1/2
D. 2 1/2
8. A. 18
, Florida Unlimited Electrical Contractor
Exam (NEC) standards 2026 Test
The entire area of an aircraft maintenance and stor-
age hangar, including an adjacent and communicating
areas not suitably cut off from the hangar, shall be
classified as a Class I, Division 2 or Zone 2 location up
to a level of inches above the floor.
A. 18
B. 24
C. 12
D. 30
9. The only calculable forces that socket-to-support B. Sign cabinet
welds must carry is the weight of the ?
A. Truss
B. Sign cabinet
C. Loads acting in only one direction
D. Wind load and weight of frame
10. A hand-held grinder with a 2-1/8" diameter wheel shall B. Momentary contact
be equipped with only a: on/ott switch
A. Constant pressure switch
B. Momentary contact on/off switch
C. Positive percussion switch
D. Positive on/off switch
11. In health care facilities, essential electrical systems B. Of two independent
shall have a MINIMUM . sources of power
A. Capacity of 200 gallons of fuel for the auxiliary gen-
erator
B. Of two independent sources of power
