C-2D Low Voltage Contractor UPDATED
SCRIPT 2026 PRACTICE SOLUTIONS
GRADED A+
● Category 6A UTP cable has a bandwidth of up to _____. Answer: 500
MHz
● The type of insulation commonly used on plenum-rated cable is ____
Answer: PTFE/Teflon®
● In optical fiber cable, the information-modulated light signal is
carried by the _ Answer: core
● Compared to a solid wire of the same gauge, stranded wire _____.
Answer: has a slightly larger diameter
● The appropriate type of rope to use for pulling cables into a conduit or
duct is low-stretch _____. Answer: double-braided polyester
● On every cable pull, it is essential to have _____. Answer: two-way
communication devices
, ● A power-limited fire alarm cable that can be used in risers is marked
as _____. Answer: FPLR
● The type of cable that is most likely to be used for medium-powered,
network-powered broadband communication in a vertical shaft space is
_____. Answer: BMR
● For high-speed data cable, the maximum pulling tension per cable is
_____. Answer: 25 foot-pounds
● According to the color code, the number of pairs of conductors in a
cable that can be defined without repeating a color combination is __
Answer: 25
● The primary solution for eliminating EMI in most installations is
_____. Answer: adequate physical separation
● Prior to attempting the pull in all but very short runs, the wires should
be _____. Answer: lubricated
● The standard conductor material for low-voltage cable is _____.
Answer: annealed copper
● Of the following, a likely cause of EMI in low-voltage circuits is
_____. Answer: sharing pathways with power circuits
SCRIPT 2026 PRACTICE SOLUTIONS
GRADED A+
● Category 6A UTP cable has a bandwidth of up to _____. Answer: 500
MHz
● The type of insulation commonly used on plenum-rated cable is ____
Answer: PTFE/Teflon®
● In optical fiber cable, the information-modulated light signal is
carried by the _ Answer: core
● Compared to a solid wire of the same gauge, stranded wire _____.
Answer: has a slightly larger diameter
● The appropriate type of rope to use for pulling cables into a conduit or
duct is low-stretch _____. Answer: double-braided polyester
● On every cable pull, it is essential to have _____. Answer: two-way
communication devices
, ● A power-limited fire alarm cable that can be used in risers is marked
as _____. Answer: FPLR
● The type of cable that is most likely to be used for medium-powered,
network-powered broadband communication in a vertical shaft space is
_____. Answer: BMR
● For high-speed data cable, the maximum pulling tension per cable is
_____. Answer: 25 foot-pounds
● According to the color code, the number of pairs of conductors in a
cable that can be defined without repeating a color combination is __
Answer: 25
● The primary solution for eliminating EMI in most installations is
_____. Answer: adequate physical separation
● Prior to attempting the pull in all but very short runs, the wires should
be _____. Answer: lubricated
● The standard conductor material for low-voltage cable is _____.
Answer: annealed copper
● Of the following, a likely cause of EMI in low-voltage circuits is
_____. Answer: sharing pathways with power circuits