ILLINOIS STATE PLUMBING EXAMS SCRIPT ALL
QUESTIONS AND ANSWERS SURE A+
✔✔A temperature and pressure relief valve shall discharge to the outside atmosphere if
a floor drain is not accessible. T or F - ✔✔False
✔✔A saddle is permissible on a potable water supply system when installing an ice
maker or humidifier T or F - ✔✔False
✔✔Section 890 Appendix A of the Illinois Plumbing Code states that plastic water piping
is acceptable for hot and cold water. T or F - ✔✔True
✔✔Flared copper joints are permissible in an underground installation for water
distribution within a building. T or F - ✔✔False
✔✔ What is the name of the chemical substance that does not allow oxides to form on
freshly cleaned copper before soldering or brazing? - ✔✔Flux
✔✔When a water supply system is tested with air, the pressure applied is - ✔✔greater
than the normal operating pressure
✔✔An escutcheon is used - ✔✔on the outside of the stub out
✔✔The trap seal is the maximum depth of liquid that a trap will retain, measured
between the crown weir and - ✔✔The top of the dip of the trap
✔✔A vent connecting one or more individual vents with a vent stack is a - ✔✔Branch
vent
✔✔A pipe which makes an angle of 60 degrees with the horizontal is considered a -
✔✔Vertical pipe
QUESTIONS AND ANSWERS SURE A+
✔✔A temperature and pressure relief valve shall discharge to the outside atmosphere if
a floor drain is not accessible. T or F - ✔✔False
✔✔A saddle is permissible on a potable water supply system when installing an ice
maker or humidifier T or F - ✔✔False
✔✔Section 890 Appendix A of the Illinois Plumbing Code states that plastic water piping
is acceptable for hot and cold water. T or F - ✔✔True
✔✔Flared copper joints are permissible in an underground installation for water
distribution within a building. T or F - ✔✔False
✔✔ What is the name of the chemical substance that does not allow oxides to form on
freshly cleaned copper before soldering or brazing? - ✔✔Flux
✔✔When a water supply system is tested with air, the pressure applied is - ✔✔greater
than the normal operating pressure
✔✔An escutcheon is used - ✔✔on the outside of the stub out
✔✔The trap seal is the maximum depth of liquid that a trap will retain, measured
between the crown weir and - ✔✔The top of the dip of the trap
✔✔A vent connecting one or more individual vents with a vent stack is a - ✔✔Branch
vent
✔✔A pipe which makes an angle of 60 degrees with the horizontal is considered a -
✔✔Vertical pipe
