SACA questions with verified answers 2026\2027 A+
Grade
What is the pressure shown on this gauge?*
- correct answer 500 kPa
What type of wrench is shown?*
- correct answer Ratchet
What amount of power is used in this circuit?*
- correct answer 96W
What type of geometric tolerance is shown in the feature control frame on this drawing?
- correct answer Circularity
A company's Emergency Action Plan (EAP) should include ALL of the following except?
- correct answer Machine operation procedures
What action must be taken to correctly position a dial caliper?
- correct answer Sweep and rock to the jaws
What type of hand tool has a cross-shaped head to engage and tighten a fastener?*
- correct answer Phillips head screwdriver
Which of these activities is considered non-value added activity in a lean manufacturing environment?*
0/4
- correct answer Moving a product from one station to another
What is the tolerance of the width of this part?*
- correct answer +/-0.1
, What do SDS sheets do?*
- correct answer Specify material hazards.
When a click-type torque wrench clicks at the set point, what do you do to apply the proper torque?
- correct answer Stop turning the wrench
What type of hole is identified by the arrow labeled A?*
- correct answer Blind
What component does the schematic represent?*
- correct answer Pneumatic motor
What type of information would not normally be found in a drawing's title block?*
0/4
- correct answer General notes
What machine can be programmed to perform tasks in many different operations?
- correct answer Robot
What could affect an inductive sensor's operation if it is mounted near the sensor?*
4/4
- correct answer metal
Which of these is NOT a primary goal of a lean manufacturing system?
- correct answer Greater production volume
In the bolt designation shown, what is the pitch?
- correct answer 2.5
What air pressure should be used when compressed air is used to clean or blow parts?
- correct answer Below 30 psi
Grade
What is the pressure shown on this gauge?*
- correct answer 500 kPa
What type of wrench is shown?*
- correct answer Ratchet
What amount of power is used in this circuit?*
- correct answer 96W
What type of geometric tolerance is shown in the feature control frame on this drawing?
- correct answer Circularity
A company's Emergency Action Plan (EAP) should include ALL of the following except?
- correct answer Machine operation procedures
What action must be taken to correctly position a dial caliper?
- correct answer Sweep and rock to the jaws
What type of hand tool has a cross-shaped head to engage and tighten a fastener?*
- correct answer Phillips head screwdriver
Which of these activities is considered non-value added activity in a lean manufacturing environment?*
0/4
- correct answer Moving a product from one station to another
What is the tolerance of the width of this part?*
- correct answer +/-0.1
, What do SDS sheets do?*
- correct answer Specify material hazards.
When a click-type torque wrench clicks at the set point, what do you do to apply the proper torque?
- correct answer Stop turning the wrench
What type of hole is identified by the arrow labeled A?*
- correct answer Blind
What component does the schematic represent?*
- correct answer Pneumatic motor
What type of information would not normally be found in a drawing's title block?*
0/4
- correct answer General notes
What machine can be programmed to perform tasks in many different operations?
- correct answer Robot
What could affect an inductive sensor's operation if it is mounted near the sensor?*
4/4
- correct answer metal
Which of these is NOT a primary goal of a lean manufacturing system?
- correct answer Greater production volume
In the bolt designation shown, what is the pitch?
- correct answer 2.5
What air pressure should be used when compressed air is used to clean or blow parts?
- correct answer Below 30 psi
