ATPL - Navigation Exam Questions and
Answers with Verified Solutions | Latest
Updated 2026
When the approach procedure c. 200 knots IAS
involves a procedure turn the
maximum speed that should
be observed from first
overheading the course
reversal IAF through the
procedure turn is a. 200 knots
TAS b. 180 knots IAS c. 200
knots IAS
What type navigation is c. by signals from self-contained
Inertial Navigation System gyros and accelerometers.
(INS)? A navigation computer
which provides position a.
from radar-type sensors that
measure ground speed and
drift angles. b. from
information by compass,
airspeed, and an input of wind
and variation data. c. by
signals from self-contained
gyros and accelerometers.
The maximum speed a c. 265 knots
propeller-driven airplane may
hold at is a. 230 knots b. 156
knots c. 265 knots
,Maximum holding speed for a b. 265 knots
turbojet airplane above 14,000
feet is a. 210 knots b. 265
knots c. 230 knots
When using a flight director a. 3° per second or 25° bank,
system, what rate of turn or whichever is less.
bank angle should a pilot
observe during turns in a
holding pattern? a. 3° per
second or 25° bank, whichever
is less. b. 3° per second or 30°
bank, whichever is less. c.
1-1/2° per second or 25° bank,
whichever is less.
When entering a holing b. 1-1/2 minutes
pattern above 14,000 feet, the
initial outbound leg should not
exceed a. 1-1/2 minutes or 10
NM, whichever is less b. 1-1/2
minutes c. 1 minute
When holding at n NDB, at b. When abeam the holding fix.
what point should the timing
begin for the second leg
outbound? a. At the end of a
1-minute standard rate turn
after station passage. b. When
abeam the holding fix. c.
Abeam the holding fix or when
the wings are level after
completing the turn to the
outbound heading, whichever
, occurs first.
[?] What functions are c. Guidance, range, and visual
provided by ILS? a. Azimuth, information
distance, and vertical angle b.
Azimuth, range, and vertical
angle c. Guidance, range, and
visual information
[?] Within what frequency b. 108.10 to 111.95 Mhz
range does the localizer
transmitter of the ILS operate?
a. 108.10 to 118.10 Mhz b.
108.10 to 111.95 Mhz c.
108.10 to 117.95 Mhz
Which component associated c. Outer compass locator
with the ILS is identified by the
first two letters of the localizer
identification group? a. Inner
marker b. Middle compass
locator c. Outer compass
locator
Which component associated b. Middle compass locator
with the ILS is identified by the
last two letters of the localizer
identification group? a. Inner
marker b. Middle compass
locator c. Outer compass
locator
If installed, what aural and a. A series of two dot combinations
visual indications should be and a white marker beacon light
Answers with Verified Solutions | Latest
Updated 2026
When the approach procedure c. 200 knots IAS
involves a procedure turn the
maximum speed that should
be observed from first
overheading the course
reversal IAF through the
procedure turn is a. 200 knots
TAS b. 180 knots IAS c. 200
knots IAS
What type navigation is c. by signals from self-contained
Inertial Navigation System gyros and accelerometers.
(INS)? A navigation computer
which provides position a.
from radar-type sensors that
measure ground speed and
drift angles. b. from
information by compass,
airspeed, and an input of wind
and variation data. c. by
signals from self-contained
gyros and accelerometers.
The maximum speed a c. 265 knots
propeller-driven airplane may
hold at is a. 230 knots b. 156
knots c. 265 knots
,Maximum holding speed for a b. 265 knots
turbojet airplane above 14,000
feet is a. 210 knots b. 265
knots c. 230 knots
When using a flight director a. 3° per second or 25° bank,
system, what rate of turn or whichever is less.
bank angle should a pilot
observe during turns in a
holding pattern? a. 3° per
second or 25° bank, whichever
is less. b. 3° per second or 30°
bank, whichever is less. c.
1-1/2° per second or 25° bank,
whichever is less.
When entering a holing b. 1-1/2 minutes
pattern above 14,000 feet, the
initial outbound leg should not
exceed a. 1-1/2 minutes or 10
NM, whichever is less b. 1-1/2
minutes c. 1 minute
When holding at n NDB, at b. When abeam the holding fix.
what point should the timing
begin for the second leg
outbound? a. At the end of a
1-minute standard rate turn
after station passage. b. When
abeam the holding fix. c.
Abeam the holding fix or when
the wings are level after
completing the turn to the
outbound heading, whichever
, occurs first.
[?] What functions are c. Guidance, range, and visual
provided by ILS? a. Azimuth, information
distance, and vertical angle b.
Azimuth, range, and vertical
angle c. Guidance, range, and
visual information
[?] Within what frequency b. 108.10 to 111.95 Mhz
range does the localizer
transmitter of the ILS operate?
a. 108.10 to 118.10 Mhz b.
108.10 to 111.95 Mhz c.
108.10 to 117.95 Mhz
Which component associated c. Outer compass locator
with the ILS is identified by the
first two letters of the localizer
identification group? a. Inner
marker b. Middle compass
locator c. Outer compass
locator
Which component associated b. Middle compass locator
with the ILS is identified by the
last two letters of the localizer
identification group? a. Inner
marker b. Middle compass
locator c. Outer compass
locator
If installed, what aural and a. A series of two dot combinations
visual indications should be and a white marker beacon light
