IEC 2nd Year Semester 1 Final Exam Questions & Answers |
Latest Already Graded A+ |Questions with Correct Answers
2026 latest update!!
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
MASTER ELECTRICIAN TEST 211 ECE FINAL 2026 ECE 315 Final Exam Co
Teacher 70 terms Teacher 37 terms Teacher 123 terms Te
Mercy_Wachira Preview kativui950 Preview WERNANGE Preview
Terms in this set (71)
[210 RW #1] On a 4-wire, delta-connected system where Orange
the midpoint of one phase winding is grounded, only
the conductor or busbar having the higher phase
voltage to ground shall be durably and permanently
marked by an outer finish that is ___ in color.
[210 RW #8] Which chapters in the Code apply Chapters 1-4
generally?
[210.1 #7] The authority having jurisdiction has the all of these
responsibility ___.
[210.1 #9] Informational Notes (I-Notes) in the National explanatory information (not mandatory)
Electrical Code® are ___.
[210.2 #4] The neutral conductor of a 120-volt circuit is grounded
referred to as the ___ conductor in the NEC®.
[210.2 #15] The definition of a branch circuit is ___. the circuit conductors between the final overcurrent device protecting the
circuit and the outlet(s)
, [210.3 #14] You need to get power to a 208-volt load. No
Your available power is from a 120/240-volt, 3Ø, 4-wire
panelboard. Is it permitted for you to run a branch
circuit from the neutral bar and a 1-pole circuit breaker
installed in breaker space #4? The CB has a 120-volt
rating.
[210.3 #17] Refer to Figure 201.15. The minimum working 3'
clearance at Point Z is ___ feet. The panel is 120/208-volt,
3Ø, 4W.
[210.3 #18] For the 120/208-volt panelboard shown in 34"
Figure 201.18, the minimum width of the working space
directly in front of the panelboard is ___.
[210.4 #5] The grounded conductor of a branch circuit II. white or gray in color
that is 6 AWG or smaller shall be ___.
[211 RW #1] Arc-fault requirements for dwelling units are 210.12
found in Section ___.
Select one:
[211 RW #5] In a single-family dwelling the receptacles 6'
shall be installed so that no point measured along the
floorline is more than ___ ft. to the nearest outlet.
[211.1 #19] A duplex receptacle with two circuits on the II or III only II. one double-pole circuit breaker III. two single-pole circuit
same yoke is permitted to have ___ as a means of breakers with tie handles
disconnect.
[211.1 #20] What is the minimum number of 20-ampere 2
branch circuits for small appliances required in a
residence?
[211.1 #24] Refer to Figure 108.014. Where this kitchen is All the receptacles
in a house, which receptacles are required to be GFCI
protected?
[211.1 #25] Although a residential basement is unfinished, GFCI protected
the homeowner wants several receptacles to be
installed. These receptacles are required to be ___.
[211.2 #9] Where loads are likely to be ON for 8 hours, 125
the computed load for sizing branch-circuit conductors
and OCPDs must be calculated by multiplying the
actual load by ___%.
Latest Already Graded A+ |Questions with Correct Answers
2026 latest update!!
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
MASTER ELECTRICIAN TEST 211 ECE FINAL 2026 ECE 315 Final Exam Co
Teacher 70 terms Teacher 37 terms Teacher 123 terms Te
Mercy_Wachira Preview kativui950 Preview WERNANGE Preview
Terms in this set (71)
[210 RW #1] On a 4-wire, delta-connected system where Orange
the midpoint of one phase winding is grounded, only
the conductor or busbar having the higher phase
voltage to ground shall be durably and permanently
marked by an outer finish that is ___ in color.
[210 RW #8] Which chapters in the Code apply Chapters 1-4
generally?
[210.1 #7] The authority having jurisdiction has the all of these
responsibility ___.
[210.1 #9] Informational Notes (I-Notes) in the National explanatory information (not mandatory)
Electrical Code® are ___.
[210.2 #4] The neutral conductor of a 120-volt circuit is grounded
referred to as the ___ conductor in the NEC®.
[210.2 #15] The definition of a branch circuit is ___. the circuit conductors between the final overcurrent device protecting the
circuit and the outlet(s)
, [210.3 #14] You need to get power to a 208-volt load. No
Your available power is from a 120/240-volt, 3Ø, 4-wire
panelboard. Is it permitted for you to run a branch
circuit from the neutral bar and a 1-pole circuit breaker
installed in breaker space #4? The CB has a 120-volt
rating.
[210.3 #17] Refer to Figure 201.15. The minimum working 3'
clearance at Point Z is ___ feet. The panel is 120/208-volt,
3Ø, 4W.
[210.3 #18] For the 120/208-volt panelboard shown in 34"
Figure 201.18, the minimum width of the working space
directly in front of the panelboard is ___.
[210.4 #5] The grounded conductor of a branch circuit II. white or gray in color
that is 6 AWG or smaller shall be ___.
[211 RW #1] Arc-fault requirements for dwelling units are 210.12
found in Section ___.
Select one:
[211 RW #5] In a single-family dwelling the receptacles 6'
shall be installed so that no point measured along the
floorline is more than ___ ft. to the nearest outlet.
[211.1 #19] A duplex receptacle with two circuits on the II or III only II. one double-pole circuit breaker III. two single-pole circuit
same yoke is permitted to have ___ as a means of breakers with tie handles
disconnect.
[211.1 #20] What is the minimum number of 20-ampere 2
branch circuits for small appliances required in a
residence?
[211.1 #24] Refer to Figure 108.014. Where this kitchen is All the receptacles
in a house, which receptacles are required to be GFCI
protected?
[211.1 #25] Although a residential basement is unfinished, GFCI protected
the homeowner wants several receptacles to be
installed. These receptacles are required to be ___.
[211.2 #9] Where loads are likely to be ON for 8 hours, 125
the computed load for sizing branch-circuit conductors
and OCPDs must be calculated by multiplying the
actual load by ___%.
