OVERHEAD CRANE UPDATED EXAMS SCRIPT
QUESTIONS AND ANSWERS SURE A+
✔✔3,800 lbs - ✔✔Steel Plate weighs 40 pounds per inch, What is the approximate
weight of a steel plate 8 ft. long, 5 ft. wide and 3 inches thick?
✔✔qualified engineer - ✔✔Overhead cranes may be modified provided they are
checked thoroughly by a?
✔✔safety latch - ✔✔All hooks should come equipped with a?
✔✔wind indicators - ✔✔Which device shall be provided for outdoor stored bridge
cranes?
✔✔all legs don't always share equal parts of the load - ✔✔What precaution should be
observed when using 3 and 4 legged bridles?
✔✔near to the limit switches - ✔✔Extreme caution should be used when using the hoist
for lifting?
✔✔inching - ✔✔What is the term used to describe very short movements during
hoisting operations?
, ✔✔O.S.H.A 1910.179 - ✔✔Which of the following regulations applies to overhead
cranes?
a)O.S.H.A. 1910.179
b)A.S.M.E. B30.5
c)O.S.H.A. 1910.180
d)A.S.M.E. B30.3
✔✔rated capacity - ✔✔Which item listed below, must be marked on all overhead
cranes?
a)Manufacturer name.
b)Maximum capacity.
c)Rated capacity.
d)Model of crane.
✔✔consult your supervisor for the proper method to remove the defective item from
service - ✔✔Whenever rigging equipment is found to be defective, what step should be
taken?
✔✔change battery at beginning of shift - ✔✔When using a remote or radio control, it is
important to?
✔✔highest capacity rating - ✔✔Before using rigging, the operator should be aware of
the?
✔✔an area where it will not cause an unsafe condition - ✔✔Overhead cranes should be
parked in?
✔✔sound a warning signal - ✔✔What should you do when the hook or load is moving
above personnel?
✔✔specifically authorized by a responsible person - ✔✔Cranes shall not be used for
side pulls unless?
✔✔the switch or circuit breaker - ✔✔According to OSHA, power supply to the runway
shall be controlled by?
✔✔recommend safety - ✔✔ASME B30 standards are designed to?
✔✔B30.2 - ✔✔What is the ASME volume that pertains to overhead cranes?
✔✔shall not be used as an operating control - ✔✔The hoist limit switch which controls
the upper limit of the load block.. (finish phrase)
QUESTIONS AND ANSWERS SURE A+
✔✔3,800 lbs - ✔✔Steel Plate weighs 40 pounds per inch, What is the approximate
weight of a steel plate 8 ft. long, 5 ft. wide and 3 inches thick?
✔✔qualified engineer - ✔✔Overhead cranes may be modified provided they are
checked thoroughly by a?
✔✔safety latch - ✔✔All hooks should come equipped with a?
✔✔wind indicators - ✔✔Which device shall be provided for outdoor stored bridge
cranes?
✔✔all legs don't always share equal parts of the load - ✔✔What precaution should be
observed when using 3 and 4 legged bridles?
✔✔near to the limit switches - ✔✔Extreme caution should be used when using the hoist
for lifting?
✔✔inching - ✔✔What is the term used to describe very short movements during
hoisting operations?
, ✔✔O.S.H.A 1910.179 - ✔✔Which of the following regulations applies to overhead
cranes?
a)O.S.H.A. 1910.179
b)A.S.M.E. B30.5
c)O.S.H.A. 1910.180
d)A.S.M.E. B30.3
✔✔rated capacity - ✔✔Which item listed below, must be marked on all overhead
cranes?
a)Manufacturer name.
b)Maximum capacity.
c)Rated capacity.
d)Model of crane.
✔✔consult your supervisor for the proper method to remove the defective item from
service - ✔✔Whenever rigging equipment is found to be defective, what step should be
taken?
✔✔change battery at beginning of shift - ✔✔When using a remote or radio control, it is
important to?
✔✔highest capacity rating - ✔✔Before using rigging, the operator should be aware of
the?
✔✔an area where it will not cause an unsafe condition - ✔✔Overhead cranes should be
parked in?
✔✔sound a warning signal - ✔✔What should you do when the hook or load is moving
above personnel?
✔✔specifically authorized by a responsible person - ✔✔Cranes shall not be used for
side pulls unless?
✔✔the switch or circuit breaker - ✔✔According to OSHA, power supply to the runway
shall be controlled by?
✔✔recommend safety - ✔✔ASME B30 standards are designed to?
✔✔B30.2 - ✔✔What is the ASME volume that pertains to overhead cranes?
✔✔shall not be used as an operating control - ✔✔The hoist limit switch which controls
the upper limit of the load block.. (finish phrase)
