How to Become a Coating Inspector - ANSWER To become a coating inspector, complete
the Coating Inspector Program (CIP) offered by NACE International. There are two levels of
certification. The CIP level 1 certification is for inspectors who perform basic, non-destruc-
tive inspections. Obtain this certification by completing the required NACE exams. CIP level 2
certification requires two years of experience in the field, as well as completion of the NACE
exams.
CIP Level 1 NACE-CIP1-001 - Coatings Inspector Program Level 1 - ANSWER CIP Level 1 co-
vers the technical and practical fundamentals of coating inspection work. Students will be
prepared to perform basic coating inspections using non-destructive techniques and instru-
mentation. Passcert provides students valid CIP Level 1 NACE-CIP1-001 dumps with
knowledge and application of coating materials, along with techniques for surface prepara-
tion.
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is
being applied. After application of the 19 coat you notice small blisters in some areas of the
applied lining.
Your FIRST preferred course of action is to: - ANSWER A. Break the blisters to see what's
inside
B. Document the problem and advise the Contractor and Owner's representative
C. Document the problem and advise the Contractor
D. Extract any liquid that may be inside the blister and send it to the lab for further analysis
Answer: B
.Dew point is the temperature at which - ANSWER A. water freezes.
B. humidity decreases
C. condensation occurs.
1
the Coating Inspector Program (CIP) offered by NACE International. There are two levels of
certification. The CIP level 1 certification is for inspectors who perform basic, non-destruc-
tive inspections. Obtain this certification by completing the required NACE exams. CIP level 2
certification requires two years of experience in the field, as well as completion of the NACE
exams.
CIP Level 1 NACE-CIP1-001 - Coatings Inspector Program Level 1 - ANSWER CIP Level 1 co-
vers the technical and practical fundamentals of coating inspection work. Students will be
prepared to perform basic coating inspections using non-destructive techniques and instru-
mentation. Passcert provides students valid CIP Level 1 NACE-CIP1-001 dumps with
knowledge and application of coating materials, along with techniques for surface prepara-
tion.
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is
being applied. After application of the 19 coat you notice small blisters in some areas of the
applied lining.
Your FIRST preferred course of action is to: - ANSWER A. Break the blisters to see what's
inside
B. Document the problem and advise the Contractor and Owner's representative
C. Document the problem and advise the Contractor
D. Extract any liquid that may be inside the blister and send it to the lab for further analysis
Answer: B
.Dew point is the temperature at which - ANSWER A. water freezes.
B. humidity decreases
C. condensation occurs.
1
