Vehicle Communication System Exam Questions and Answers| 2026/27Updated

Vehicle Communication System Exam
Questions and Answers| Updated


what is the resistance of the terminating resistor on networks equipped with
one start connector?
60 ohms


with the bus active and no faults present, what voltages should be measured on
CAN-C(+)?
approximately 3.2v


what Atlantis-high network uses splice block connectors?
CAN-BH


with the bus active and no faults present, what voltages should be measured on
CAN-B(-)?
approximately 0.4v


which resource should be used first for troubleshooting DRB III Emulator
concerns?
wiTECH knowledge base

, With The Bus Active And No Faults Present, What Voltages Should Be Measured
On LIN?
7.0v-10.0v


What Electrical Architecture Requires The Use Of The Mopar Diagnostic Pod
(MPD) For Diagnostics?
Atlantis-High


Which Of The Following Scan Tool Functions Ate Prevented If A Security Gateway
(SGW) Becomes Locked? Select All That Apply.
Start An Actuator
Run A System Test
Flash Program A Module


With The Bus Active And No Faults Present, What Voltages Should Be Measured
On CAN-C(-)?
Approximately 1.8v




What Atlantis Vehicles Uses Splice Block Connectors On Their CAN Buses? Select
All That Apply.
Ga Alfa Glulia
Mp Jeep Compass