CHEM 1034 LAB FINAL 9-11 EXAM STUDY GUIDE
For this experiment, you will use the NaOH solution from last week's experiment
8. Thus, you will not need to re-standardize this base solution.
true
false - ANSWER true
For a diprotic acid, pka2 is _____ pka1. (Choose the best answer.)
unrelated to
greater than
less than
equal to - ANSWER greater than
When titrating a weak diprotic acid, pka1 can be determined as follows:
1. determine the volume of titrant (v1) required to reach the first equivalence
point
2. determine the pH corresponding to a volume of titrant equaling 1/2 v1
3. pka1 = this pH
true
false - ANSWER true
When titrating a weak diprotic acid, pka2 can be determined as follows:
1. determine the volume of titrant (v1) required to reach the first equivalence
point
2. determine the pH corresponding to a volume of titrant equaling 1/2 v1
3. pka2 = this pH
true
false - ANSWER false
, The duration of each titration of phosphoric acid with sodium hydroxide will be
3 minutes
8 minutes
as long as required for pH to reach 12
as long as required to observe the second equivalence point - ANSWER as long
as required for pH to reach 12
Titrant volumes should be recorded to _____ decimal places in your lab
notebook.
1
2
3
4 - ANSWER 2
You should not discard your data from the Labquest until after you have
completed the experiment. If data is discarded during the experiment, you may
have to re-calibrate the drop counter.
true
false - ANSWER true
The mass of the unknown acid should be recorded to _____ decimal place(s).
1
2
3
4 - ANSWER 4
Select the sensor(s) attached to the Labquest for this experiment.
(Select all that apply.)
pH
temperature
drop counter
conductivity - ANSWER pH
drop counter
For this experiment, you will use the NaOH solution from last week's experiment
8. Thus, you will not need to re-standardize this base solution.
true
false - ANSWER true
For a diprotic acid, pka2 is _____ pka1. (Choose the best answer.)
unrelated to
greater than
less than
equal to - ANSWER greater than
When titrating a weak diprotic acid, pka1 can be determined as follows:
1. determine the volume of titrant (v1) required to reach the first equivalence
point
2. determine the pH corresponding to a volume of titrant equaling 1/2 v1
3. pka1 = this pH
true
false - ANSWER true
When titrating a weak diprotic acid, pka2 can be determined as follows:
1. determine the volume of titrant (v1) required to reach the first equivalence
point
2. determine the pH corresponding to a volume of titrant equaling 1/2 v1
3. pka2 = this pH
true
false - ANSWER false
, The duration of each titration of phosphoric acid with sodium hydroxide will be
3 minutes
8 minutes
as long as required for pH to reach 12
as long as required to observe the second equivalence point - ANSWER as long
as required for pH to reach 12
Titrant volumes should be recorded to _____ decimal places in your lab
notebook.
1
2
3
4 - ANSWER 2
You should not discard your data from the Labquest until after you have
completed the experiment. If data is discarded during the experiment, you may
have to re-calibrate the drop counter.
true
false - ANSWER true
The mass of the unknown acid should be recorded to _____ decimal place(s).
1
2
3
4 - ANSWER 4
Select the sensor(s) attached to the Labquest for this experiment.
(Select all that apply.)
pH
temperature
drop counter
conductivity - ANSWER pH
drop counter