3/20/26, 11:51 AM API 1169. study test questions test RM#1
API 1169. study test questions test RM#1 EXAM 2026 Most Recent
Exam Actual Complete Real Exam Questions And Correct
Answers (Verified Answers) Already Graded A+ ||
Guaranteed Success!! Newest Exam | Just Released!!
According to FERC, environmental Inspectors shall have ___ status in regards to
all
other craft inspectors.
Equal
According to Title 49 CFR 195, any new pipe with a diameter greater than_ inches
must be marked with the specification, the SMYS/Grade, and pipe size.
4.5
This legislation covers hazardous substance, site contamination, and cleanup
Comprehensive environmental recovery, compensation, and liability act.
A blueprint showing the exact route of a pipeline and virtually all of the
knowledge that exist for that pipeline when constructed is called a
_______________________________________________________ ?
Alignment sheets
In area is considered oxygen deficient if the oxygen level is below _ %
19.5
1/26
,3/20/26, 11:51 AM API 1169. study test questions test RM#1
During a pressure test, if a leak develops on a connection, yomust depressurize to
a safe level and then
re-tighten the connections
Which listed non-destructive testing method is specified in API 1104?
RT examination
Prior to a hydrotest, ensure that the _ has approved the de-watering location.
Environmental Inspector
As an inspector, you should ensure that there is always a (n) on a site with an
open excavation.
designated competent person
(Choose all correct answers) of all known utilities in an area must have been
performed prior to ANY mechanical ground disturbance.
Sweep locating, Potholing, One calls
Line locating crews should sweep
in a grid pattern (in multiple directions)
2/26
, 3/20/26, 11:51 AM API 1169. study test questions test RM#1
Transportation, installation, or repair of pipe shall not reduce the wall
thickness at any point to a thickness less than of the nominal wall
thickness as determined by
ASME B31.8 for the design pressure to which the pipe is to be subjected.
90%
The stringer bead shall be inspected, particularly for ____ before subsequent
beads
are applied.
cracks
The minimum distance a piece of equipment (generator, water pump, etc.)
should be kept from the edge of an excavation is
2 foot
Calculate the OD to WT ratio of a pipeline. The OD is 36". The WT is 0.750".
48 to 1
Lacerations from shavings, bums from hot shavings, and eye injuries from
shavings are all hazards of what activity?
pipe facing
Hearing protection during a hydro-test requirements state that the protection
level must be adequate to reduce the noise to at least below decibels
80
3/26
API 1169. study test questions test RM#1 EXAM 2026 Most Recent
Exam Actual Complete Real Exam Questions And Correct
Answers (Verified Answers) Already Graded A+ ||
Guaranteed Success!! Newest Exam | Just Released!!
According to FERC, environmental Inspectors shall have ___ status in regards to
all
other craft inspectors.
Equal
According to Title 49 CFR 195, any new pipe with a diameter greater than_ inches
must be marked with the specification, the SMYS/Grade, and pipe size.
4.5
This legislation covers hazardous substance, site contamination, and cleanup
Comprehensive environmental recovery, compensation, and liability act.
A blueprint showing the exact route of a pipeline and virtually all of the
knowledge that exist for that pipeline when constructed is called a
_______________________________________________________ ?
Alignment sheets
In area is considered oxygen deficient if the oxygen level is below _ %
19.5
1/26
,3/20/26, 11:51 AM API 1169. study test questions test RM#1
During a pressure test, if a leak develops on a connection, yomust depressurize to
a safe level and then
re-tighten the connections
Which listed non-destructive testing method is specified in API 1104?
RT examination
Prior to a hydrotest, ensure that the _ has approved the de-watering location.
Environmental Inspector
As an inspector, you should ensure that there is always a (n) on a site with an
open excavation.
designated competent person
(Choose all correct answers) of all known utilities in an area must have been
performed prior to ANY mechanical ground disturbance.
Sweep locating, Potholing, One calls
Line locating crews should sweep
in a grid pattern (in multiple directions)
2/26
, 3/20/26, 11:51 AM API 1169. study test questions test RM#1
Transportation, installation, or repair of pipe shall not reduce the wall
thickness at any point to a thickness less than of the nominal wall
thickness as determined by
ASME B31.8 for the design pressure to which the pipe is to be subjected.
90%
The stringer bead shall be inspected, particularly for ____ before subsequent
beads
are applied.
cracks
The minimum distance a piece of equipment (generator, water pump, etc.)
should be kept from the edge of an excavation is
2 foot
Calculate the OD to WT ratio of a pipeline. The OD is 36". The WT is 0.750".
48 to 1
Lacerations from shavings, bums from hot shavings, and eye injuries from
shavings are all hazards of what activity?
pipe facing
Hearing protection during a hydro-test requirements state that the protection
level must be adequate to reduce the noise to at least below decibels
80
3/26
