NASCLA Electrical Exam Newest 2026 Questions
and Correct Detailed Answers Already Graded A+
The load for household electric clothes dryers in a dwelling unit shall be either
________ or the nameplate rating, whichever is larger for each dryer served. -
CORRECT ANSWER-5000w (220.54)
When two or more single phase dryers are supplied by a 3-phase 4-wire feeder or
service, the total load shall be calculated on the basis of ____________ the
maximum number connected between any two phases. - CORRECT ANSWER-
twice
It shall be permissible to calculate the load for commercial electric cooking
equipment, dishwasher booster heaters, water heaters, and other kitchen
equipment in accordance with table 220.56. The demand factor for these units is
___________ percent for the first two devices, and ____________ percent for the
third and _________ percent for the fourth. - CORRECT ANSWER-100, 90, 80
Kitchen equipment demand factors shall not apply for ___________,
____________, and _______________ equipment - CORRECT ANSWER-Space
heating, ventilating, or air conditioning. (continuous)
, Optional load calculations for dwellings allow for:
100% of the first 10kva plus 40% of the remainder of the following loads:
_________ VA per square foot for general lighting and receptacles
_________ VA for each 2-wire 20-A small appliance branch circuit and each
laundry branch circuit
_________ VA for all appliances fastened in place permanently connected, or
located on a specific circuit.
_________ VA for all motors
Add this with the heating and Air conditioning load - CORRECT ANSWER-3
1500
Name Plate
Name Plate
The optional method of calculation for dwelling units is reserved for - CORRECT
ANSWER-dwelling units supplied by service conductors with an ampacity of 100
amperes or greater.
and Correct Detailed Answers Already Graded A+
The load for household electric clothes dryers in a dwelling unit shall be either
________ or the nameplate rating, whichever is larger for each dryer served. -
CORRECT ANSWER-5000w (220.54)
When two or more single phase dryers are supplied by a 3-phase 4-wire feeder or
service, the total load shall be calculated on the basis of ____________ the
maximum number connected between any two phases. - CORRECT ANSWER-
twice
It shall be permissible to calculate the load for commercial electric cooking
equipment, dishwasher booster heaters, water heaters, and other kitchen
equipment in accordance with table 220.56. The demand factor for these units is
___________ percent for the first two devices, and ____________ percent for the
third and _________ percent for the fourth. - CORRECT ANSWER-100, 90, 80
Kitchen equipment demand factors shall not apply for ___________,
____________, and _______________ equipment - CORRECT ANSWER-Space
heating, ventilating, or air conditioning. (continuous)
, Optional load calculations for dwellings allow for:
100% of the first 10kva plus 40% of the remainder of the following loads:
_________ VA per square foot for general lighting and receptacles
_________ VA for each 2-wire 20-A small appliance branch circuit and each
laundry branch circuit
_________ VA for all appliances fastened in place permanently connected, or
located on a specific circuit.
_________ VA for all motors
Add this with the heating and Air conditioning load - CORRECT ANSWER-3
1500
Name Plate
Name Plate
The optional method of calculation for dwelling units is reserved for - CORRECT
ANSWER-dwelling units supplied by service conductors with an ampacity of 100
amperes or greater.
