Page 1 Journeyman Plumber Test
Journeyman Plumber Test Save
Terms in this set (218)
A 1/2" iron pipe properly threaded D. 1 and 3
would have _ threads.
1). 3/4" of threads. 2). Approximately 7.
3). Approximately 10.
A. 1 only
B. 2 only
C. 3 only
D. 1 and 3
The 3 parts of a plumbing system are: Drains, vents and water lines
Journeyman Plumber Test 1
,Page 2 Journeyman Plumber Test
An 80ft tall pipe that has 58ft of water 25
column will have _ psi at the bottom
of the pipe?
After calling UPC for a utility locate, 48 hours
how long do you allow for them to
make the line?
Air may be used to test a potable B. The pipes are metallic
water system or part thereof if _?
A. A hand air pump is used
B. The pipes are metallic
C. If the pressure is not less than 50psi
D. If the medium is from a
contaminated source.
Journeyman Plumber Test 2
,Page 3 Journeyman Plumber Test
All drainpipes from upstream fixture 1/4 inch
connected to a grease interceptor
shall have a minimum fall of _ inch per
feet.
All horizontal drains within a building D. 100
shall be provided with cleanouts
located not more than _ ft apart.
A. 25
B. 50
C. 80
D. 100
All hospitals shall have a minimum of _ 2
water service pipes connected to the
public water system.
Journeyman Plumber Test 3
, Page 4 Journeyman Plumber Test
All water closets shall be designed 128
such that they will adequately flush
using no more than _________ gallons per
flush cycle.
Any pipe passing through a C. Relieving arch or a pipe sleeve
foundation wall shall be protected by
using a __ or a __.
A. Iron pipe or a steel pipe
B. PVC pipe or a CPVC pipe
C. Relieving arch or a pipe sleeve
D. None of the above
Appliances located in public garages, 8'
service stations, repairs garages or
other areas or other areas frequented
by motor vehicles, shall be installed a
minimum of _ above the floor.
Journeyman Plumber Test 4
Journeyman Plumber Test Save
Terms in this set (218)
A 1/2" iron pipe properly threaded D. 1 and 3
would have _ threads.
1). 3/4" of threads. 2). Approximately 7.
3). Approximately 10.
A. 1 only
B. 2 only
C. 3 only
D. 1 and 3
The 3 parts of a plumbing system are: Drains, vents and water lines
Journeyman Plumber Test 1
,Page 2 Journeyman Plumber Test
An 80ft tall pipe that has 58ft of water 25
column will have _ psi at the bottom
of the pipe?
After calling UPC for a utility locate, 48 hours
how long do you allow for them to
make the line?
Air may be used to test a potable B. The pipes are metallic
water system or part thereof if _?
A. A hand air pump is used
B. The pipes are metallic
C. If the pressure is not less than 50psi
D. If the medium is from a
contaminated source.
Journeyman Plumber Test 2
,Page 3 Journeyman Plumber Test
All drainpipes from upstream fixture 1/4 inch
connected to a grease interceptor
shall have a minimum fall of _ inch per
feet.
All horizontal drains within a building D. 100
shall be provided with cleanouts
located not more than _ ft apart.
A. 25
B. 50
C. 80
D. 100
All hospitals shall have a minimum of _ 2
water service pipes connected to the
public water system.
Journeyman Plumber Test 3
, Page 4 Journeyman Plumber Test
All water closets shall be designed 128
such that they will adequately flush
using no more than _________ gallons per
flush cycle.
Any pipe passing through a C. Relieving arch or a pipe sleeve
foundation wall shall be protected by
using a __ or a __.
A. Iron pipe or a steel pipe
B. PVC pipe or a CPVC pipe
C. Relieving arch or a pipe sleeve
D. None of the above
Appliances located in public garages, 8'
service stations, repairs garages or
other areas or other areas frequented
by motor vehicles, shall be installed a
minimum of _ above the floor.
Journeyman Plumber Test 4
