Florida Pump Operator Exam Questions with Correct Answers 100% Verified by Experts|
2025/2026 Latest Update
____________reduces the possibility of an apparatus going into a slide, jackknife, or spin during
heavy braking ABS
Railroad companies advise that vehicles be kept at least __________ from tracks. 25
feet(7.5m)
What should D/O check in regards to tires on apparatus? -Check the tire type, condition, and
inflation. Ensure not a mix of radial and bias-ply tires.
-Too much or too little tire pressure will damage tires, cause poor road handling, and excessive
fuel consumption.
-Tires should be replaced every seven (7) years, regardless of condition according to NFPA 1911.
-Should be no more than 10 degrees steering wheel play, in either direction.
-NFPA 1901 and 1911 states that side-to-side variance in weight should not exceed 7%.
-Most modern apparatus are equipped with Air-actuated braking system (air brakes)
Ensure what before raising cab? Shut down apparatus, chock wheels. Before lifting cab, be
sure adequate vertical clearance.
What to do first when finding issue with apparatus that needs repair? - D/O Documents
defective system per SOP then notify supervisor of the defect and documentation
What is best flow pattern for a water shuttle operation? A circular route is the optimum
arrangement for water shuttle circuit. Always try to maintain forward movement to reduce
backing.
The most suitable drafting site to meet the safety and flow requirements may not always be the
______________________________ . geographically closest site
, Nurse tender and portable water tank will be located at _____________. Dump sites.
A ____________ consists of an intake hose connection on the shore and a length of pipe
extended into the water with a strainer on the end; at water source, usually in rural areas.
dry hydrant
Backing and Spotting Backing straight - Spotter uses back and forth motion with both arms
and palms face spotter
Backing to left - Point left with appropriate arm and palm facing D/O and use other arm similar
to backing straight
Backing to Right - Point Right with appropriate arm and palm facing D/O and use other arm
similar to backing straight
Slowing down - Spotter's arms out to the side with palms facing down. Raising arms up and
down.
Stopping - Spotter crosses both forearms into a large X
Pull forward and reestablish backing - Spotter signals D/O to stop, then pull forward by
signaling with palms facing forward and motions back and forth in a pushing action. After
repositioning, resume backing operation.
If D/O cannot see spotter or feels unsafe, he should: stop, set parking brake, get out of
apparatus, and check with everyone involved
Floating pump capacity is _____________. 500 gpm
Floating strainer may be used in water as shallow as _______________ . 1 foot of water
2025/2026 Latest Update
____________reduces the possibility of an apparatus going into a slide, jackknife, or spin during
heavy braking ABS
Railroad companies advise that vehicles be kept at least __________ from tracks. 25
feet(7.5m)
What should D/O check in regards to tires on apparatus? -Check the tire type, condition, and
inflation. Ensure not a mix of radial and bias-ply tires.
-Too much or too little tire pressure will damage tires, cause poor road handling, and excessive
fuel consumption.
-Tires should be replaced every seven (7) years, regardless of condition according to NFPA 1911.
-Should be no more than 10 degrees steering wheel play, in either direction.
-NFPA 1901 and 1911 states that side-to-side variance in weight should not exceed 7%.
-Most modern apparatus are equipped with Air-actuated braking system (air brakes)
Ensure what before raising cab? Shut down apparatus, chock wheels. Before lifting cab, be
sure adequate vertical clearance.
What to do first when finding issue with apparatus that needs repair? - D/O Documents
defective system per SOP then notify supervisor of the defect and documentation
What is best flow pattern for a water shuttle operation? A circular route is the optimum
arrangement for water shuttle circuit. Always try to maintain forward movement to reduce
backing.
The most suitable drafting site to meet the safety and flow requirements may not always be the
______________________________ . geographically closest site
, Nurse tender and portable water tank will be located at _____________. Dump sites.
A ____________ consists of an intake hose connection on the shore and a length of pipe
extended into the water with a strainer on the end; at water source, usually in rural areas.
dry hydrant
Backing and Spotting Backing straight - Spotter uses back and forth motion with both arms
and palms face spotter
Backing to left - Point left with appropriate arm and palm facing D/O and use other arm similar
to backing straight
Backing to Right - Point Right with appropriate arm and palm facing D/O and use other arm
similar to backing straight
Slowing down - Spotter's arms out to the side with palms facing down. Raising arms up and
down.
Stopping - Spotter crosses both forearms into a large X
Pull forward and reestablish backing - Spotter signals D/O to stop, then pull forward by
signaling with palms facing forward and motions back and forth in a pushing action. After
repositioning, resume backing operation.
If D/O cannot see spotter or feels unsafe, he should: stop, set parking brake, get out of
apparatus, and check with everyone involved
Floating pump capacity is _____________. 500 gpm
Floating strainer may be used in water as shallow as _______________ . 1 foot of water
