Risk Management & Prep of SOP for Ammo & Exp Exam Questions with Answers

Risk Management & Prep of SOP for Ammo & Exp Exam Questions with Answers Which type of risk endangers lives or resources without contributing to mission accomploishment? - ANSWER-An unnecessary risk Which Army publication provides specific information to implement RM policies and procedures? - ANSWER-DA PAM 385-30 In which phase of the RM process is the hazard control plan developed and put into action? - ANSWER-Management phase In the assessment phase, RM practitioners identify hazards and - ANSWER-Assess hazards what is a condition with the potential to cause a harmful event such as injury, illness, or loss of equipment of property? - ANSWER-Hazard In this hazard scenario, what is the outcome? Stored blasting materials + Exposure to heat = Detonation or explosion - ANSWER-Detonation or explosion Why does the RM practitioner estimate the probability and level of severity for each hazard in step 2 of the RM process? - ANSWER-To assign a level of risk to each hazard. Which term describes the extent of expected harm from an event, in terms of amount of injury, property damage, or other mission-impairing effect? - ANSWER-Severity 2 | Page Per ATP 5-19, Table 1-1, what is the probability for a harmful occurrence expected to happen infrequently (remotely possible, could occur at some time)? - ANSWER-Unlikely (NOT THE ANSWER) Per ATP 5-19, Table 1-1, what is the severity of a hazard if its expected consequences include complete mission failure or unacceptable collateral damage? - ANSWER-Severity is estimated as >CATASTROPHIC< when consequences of an event, if it occurs, are expected to include death, unacceptable loss or damage, mission failure, or the loss of unit readiness. Per ATP 5-19, Table 1-1, what is the risk level for a hazard with likely probability and negligible severity - ANSWER-Low Which information is NOT part of a hazard control action plan? - ANSWER-Negotiations When supervising action plans, which action is NOT something supervisors do to ensure awareness, training, and compliance? - ANSWER-Delegate supervisor duties Which is NOT a goal of evaluation feedback? - ANSWER-Ensure hazard controls are not revised once they are implemented The Army requires SOPs for complex tasks, those involving hazardous materials, and - ANSWER All operations involving A&E What is the purpose of an SOP? - ANSWER-To provide clear, concise guidance to operation personnel and aid in the training of operators. Several publications may be referenced when developing SOPs including DA PAM 700-107, ATP 3-90.90, and - ANSWER-The SOP portal 3 | Page What is the last step in the sop development process? - ANSWER-Review SOP When developing an SOP, the first step is to - ANSWER-Determine the SOP objective. When writing an SOP, which step requires you to explain each operating procedure in detail including how to carry it out? - ANSWER-Write detailed operating instructions Select the correct sequence of steps used for SOP review and concurrence. - ANSWER-Assemble SOP, review SOP, preform pilot run. Who must approve the SOP locally before the installation commander approves it? - ANSWER Concurring agencies What is the most important aspect to successful implementation of controls? - ANSWER Communication All active SOPs (except demilitarization and disposal, toxic chemicals, AMC A&E, and hazardous operations) must be reviewed - ANSWER-Annually, biennially Which statement does NOT describe the purpose of an SOP? - ANSWER-To allow personnel to create and implement new operational procedures on the fly. Which element is NOT an essential SOP requirement? - ANSWER-Risk management matrix Which hazard control is implemented through the wearing of hard hats, safety glasses, and respirators? - ANSWER-PPE In which phase of the RM process does research take place? - ANSWER-Management phase