Complete Questions And Correct Detailed Answers|
Brand New Version!
A piping drawing that shows both side view and top view of a piping
system is
isometric
the movement of pipe that is caused by an increase in temperature is
called
Thermal expansion
A cold spring relieves..
Thermal expansion
How many feet apart must oxygen and fuel gas cylinders be stored,
unless the is a 5 ft high, 30 minute burn rated wall between them?
20
1|Page
,When performing a line break, first?
break the bolts down & away from you
A pipe nipple is any length of threaded pipe that is shorter than..
12"
what is the reference angle if the hypotenuse of a right triangle is 36"
and its adjacent side is 14" .
(pipe fitters blue book)
67 degrees
in piping systems, ball joints are installed to allow for?
Expansion and Contraction
All of the following drawing dimensions are used to determine the
overall length of Run of a pipe EXCEPT
2|Page
, pipe diameter
Ground Fault Circuit Interrupters SHOULD be located..
On cords with only 3 prong connections
What is the most important hazardous condition in or around an
excavation?
Cave-in
What happens when a misaligned pipe flange is bolted up to an aligned
pump's suction?
The pump and motor will be out of alignment
A pretest field inspection includes all of the following EXCEPT the ..
Vent at the low point of the system
3|Page