Massachusetts oil burner study
guide 2025 COMPLETE EXAM
QUESTIONS AND VERIFIED
ANSWERS| 100% ACCURATE
SOLUTIONS|ALREADY GRADED A+
Save
Terms in this set (193)
What is the 24 volts
voltage found at
the TT terminals
, 1 talk to customer 2 check tt.3 check
to make sure an emergency switch
is on 4check to make sure there is
oil in the tank 5 check to make sure
the main power going to the unit is
What are the 8
on six check to make sure that tank
steps of a no
shut off valve is open 7 know
heat call
whether the tank is located above
or below the burner I know the
type and style of the system that is
being used on a one or two pipe
system
A device containing condominium
What is a cad
sulfide used to prove the flame in
cell
oil burner furnace
How much air is In 2015 most oil burners are set up
needed to burn to burn with approximately 50%
a gallon of excess air because it would be
number 2 fuel oil dangerous to set up a burner for
and why. exactly the correct amount of air
What is the term The stack relay is operating
InStep mean correctly
What is normal 100 PSI
pump pressure
, How is Atomization, air, ignition.
combustion
achieved
Primary air, air that is introduced to
a furnace burner before the
What is primary combustion process has taken
air and place. secondary air, air that is
secondary air introduced to the furnace after
combustion has taken place and
that supports combustion
How should an It shall be secured attached to a
oil tank be non-combustible supports
supported
What is the wire 14 gauge 15 amp fuse
gauge use an oil
burner circuits
Shall be wired on its own circuit. All
protective control and emergency
devices shall be series connected
How is an oil
in the grounded line conductors. all
burner wired
the electrical wiring shall be in
accordance with 527 CMR 12.00
Massachusetts electrical code
guide 2025 COMPLETE EXAM
QUESTIONS AND VERIFIED
ANSWERS| 100% ACCURATE
SOLUTIONS|ALREADY GRADED A+
Save
Terms in this set (193)
What is the 24 volts
voltage found at
the TT terminals
, 1 talk to customer 2 check tt.3 check
to make sure an emergency switch
is on 4check to make sure there is
oil in the tank 5 check to make sure
the main power going to the unit is
What are the 8
on six check to make sure that tank
steps of a no
shut off valve is open 7 know
heat call
whether the tank is located above
or below the burner I know the
type and style of the system that is
being used on a one or two pipe
system
A device containing condominium
What is a cad
sulfide used to prove the flame in
cell
oil burner furnace
How much air is In 2015 most oil burners are set up
needed to burn to burn with approximately 50%
a gallon of excess air because it would be
number 2 fuel oil dangerous to set up a burner for
and why. exactly the correct amount of air
What is the term The stack relay is operating
InStep mean correctly
What is normal 100 PSI
pump pressure
, How is Atomization, air, ignition.
combustion
achieved
Primary air, air that is introduced to
a furnace burner before the
What is primary combustion process has taken
air and place. secondary air, air that is
secondary air introduced to the furnace after
combustion has taken place and
that supports combustion
How should an It shall be secured attached to a
oil tank be non-combustible supports
supported
What is the wire 14 gauge 15 amp fuse
gauge use an oil
burner circuits
Shall be wired on its own circuit. All
protective control and emergency
devices shall be series connected
How is an oil
in the grounded line conductors. all
burner wired
the electrical wiring shall be in
accordance with 527 CMR 12.00
Massachusetts electrical code
