MSSC - Quality Certification Questions and Answers Already Passed

MSSC - Quality Certification Questions and Answers Already Passed Which is NOT one of the steps used in the glass box method? - Answer ️️ -rotate object in glass box The three standard views of an object are ______. - Answer ️️ -top, front, right side What is the order of precedence of lines in a drawing? - Answer ️️ -object, hidden, center What type of feature is parallel to the surface being dimensioned? - Answer ️️ -dimension line A ______ dimension is described in inches per foot. - Answer ️️ -shaft taper To establish on a drawing that 1/4 inch equals 1 inch, the designer would write ______. - Answer ️️ -1/4 = 1 Section lines on a blueprint include _______. - Answer ️️ -a surface that has been cut In a threaded fastener assembly what is designed to protect the threads? - Answer ️️ -shank The minor diameter of a screw thread is measured at the ______. - Answer ️️ -root of screw thread The minor diameter of a threaded fastener is ______. - Answer ️️ -the major diameter minus the thread height How do you determine the grade of a bolt? - Answer ️️ -number of lines on the head +2 indicates the grade A screw with National fine thread is represented on a drawing with what designation? - Answer ️️ -NF Metals treated by ______ processes become soft. - Answer ️️ -annealing A running fit is also called a(n) ______. - Answer ️️ -sliding fit The term ______ refers to a physical portion of a part. - Answer ️️ -feature A(n) _______ is a theoretically perfect line, point or pane that is located by a similar feature or part. - Answer ️️ -datum GD&T _________________. - Answer ️️ -allows certain tolerances on part features to be increased A feature control frame is not used to describe ______. - Answer ️️ -measurements A common decimal inch rule graduation is in _______. - Answer ️️ -50ths A scale typically found on a machinist rule is _______. - Answer ️️ -1/16 Resolution is sometimes called ______. - Answer ️️ -discrimination A common fractional inch rule graduation is in _______. - Answer ️️ -32nds One inch is equal to _______. - Answer ️️ -25.4mm A typical dial caliper can be used to measure dimensions to the nearest ________ inches. - Answer ️️ -0.001 Calibration means to ______. - Answer ️️ -adjust a device to a standard The typical accuracy of a dial caliper is about ______ inches. - Answer ️️ -0.00