IICRC WRT TesT (110 seTs) 2023| gRaded
a+
#1. During the inspection process, restorers shall make a reasonable effort to -
ANSWER C. identify and address potential safety hazards
#2. A significant amount of water absorption and evaporation load where wet
porous materials represent ~5% to ~40% of combined ceiling, walls, and flooring
surface areas and where low evaporation materials and assemblies are minimally
wet is - ANSWER B. class 2
#3. Multiple extraction of salvageable materials, especially porous material (e.g.
Carpet , cushion) often are required to: - ANSWER decrease drying time
#4. To enhance drying, restorers should manage both ambient temperature and -
ANSWER surface temperatures of affected materials
#5. Water damage restoration services should not begin until after the: -
ANSWER restorer has entered into an adequately written contract.
#6. Two tools that should be used to properly disengage most stretched-in carpet -
ANSWER Knee kicker and carpet awl
#7. When inspecting a water damage structure, restorers should inspect: -
ANSWER all potentially affected areas.
#8. Buckled or damaged particle board should - ANSWER removed and
replaced with new material.
#9. upon entering a building, professional moisture detection equipment should be
used to evaluate and document: - ANSWER applicable psychrometric
conditions and moisture content or level readings .
#10. When wet, a structural material that loses most of its structural integrity, but
regains its strength when dry, is: - ANSWER Concrete
, IICRC WRT TesT (110 seTs) 2023| gRaded
a+
#11 Initially, a method of search for abnormal moisture behind ceramic tile or
resilient flooring can be accomplished by - ANSWER using a non-penetrating
(non-invasive) moisture meter
#12. To minimize damage and reduce drying time, reduce drying time, restorers
should: - ANSWER begin mitigation as soon as safely possible
#13. The moisture content of structural materials should be measured with a -
ANSWER A. moisture meter
#14. When accessible from below, to dry wet wood subflooring under stone or tile
flooring, restorers can use low-humidity air and - ANSWER D. vapor barrier
#15. Biocides designed to destroy or eliminate all forms of microbial life and their
spores are - ANSWER D. sterilizers
#16. When carpet is wet it can be delaminated by - ANSWER D. improper
handling and disengaging
#17. To minimize or control aerosolized soils or contaminants during restoration,
restorers can: - ANSWER B. install one or more air filtration devices (AFDs)
#18. When pre-existing damage is discovered, restorer should - ANSWER D.
document and bring it to the attention of materially interested parties
#19. Rapid drying of structural materials is achieved by - ANSWER A.
promoting evaporation and dehumidification or ventilation
#20. When carpet and cushion (pad, underlay) are saturated with Category 3 water
- ANSWER B. Both should be removed for proper disposal
a+
#1. During the inspection process, restorers shall make a reasonable effort to -
ANSWER C. identify and address potential safety hazards
#2. A significant amount of water absorption and evaporation load where wet
porous materials represent ~5% to ~40% of combined ceiling, walls, and flooring
surface areas and where low evaporation materials and assemblies are minimally
wet is - ANSWER B. class 2
#3. Multiple extraction of salvageable materials, especially porous material (e.g.
Carpet , cushion) often are required to: - ANSWER decrease drying time
#4. To enhance drying, restorers should manage both ambient temperature and -
ANSWER surface temperatures of affected materials
#5. Water damage restoration services should not begin until after the: -
ANSWER restorer has entered into an adequately written contract.
#6. Two tools that should be used to properly disengage most stretched-in carpet -
ANSWER Knee kicker and carpet awl
#7. When inspecting a water damage structure, restorers should inspect: -
ANSWER all potentially affected areas.
#8. Buckled or damaged particle board should - ANSWER removed and
replaced with new material.
#9. upon entering a building, professional moisture detection equipment should be
used to evaluate and document: - ANSWER applicable psychrometric
conditions and moisture content or level readings .
#10. When wet, a structural material that loses most of its structural integrity, but
regains its strength when dry, is: - ANSWER Concrete
, IICRC WRT TesT (110 seTs) 2023| gRaded
a+
#11 Initially, a method of search for abnormal moisture behind ceramic tile or
resilient flooring can be accomplished by - ANSWER using a non-penetrating
(non-invasive) moisture meter
#12. To minimize damage and reduce drying time, reduce drying time, restorers
should: - ANSWER begin mitigation as soon as safely possible
#13. The moisture content of structural materials should be measured with a -
ANSWER A. moisture meter
#14. When accessible from below, to dry wet wood subflooring under stone or tile
flooring, restorers can use low-humidity air and - ANSWER D. vapor barrier
#15. Biocides designed to destroy or eliminate all forms of microbial life and their
spores are - ANSWER D. sterilizers
#16. When carpet is wet it can be delaminated by - ANSWER D. improper
handling and disengaging
#17. To minimize or control aerosolized soils or contaminants during restoration,
restorers can: - ANSWER B. install one or more air filtration devices (AFDs)
#18. When pre-existing damage is discovered, restorer should - ANSWER D.
document and bring it to the attention of materially interested parties
#19. Rapid drying of structural materials is achieved by - ANSWER A.
promoting evaporation and dehumidification or ventilation
#20. When carpet and cushion (pad, underlay) are saturated with Category 3 water
- ANSWER B. Both should be removed for proper disposal
