ASE FINAL EXAM PRACTICE
QUESTIONS AND ANSWERS 2022
A technician is performing a load test on a battery and finds the battery to below
specifications. Which of the following is the best action to taken next? a Perform a
resistance test on the battery
b Recharge the battery and sell it as a used battery
c Recharge the battery and retest it
d Drain the battery completely and recharge it - c Recharge the battery and retest it
Two technicians are discussing a whining noise heard through the radio. Technician A
says a faulty alternator stator can cause the problem. Technician B says a faulty diode
is most likely the cause. Who's correct?
Tech A
Tech B
Both A and B
Neither A nor B - Both A and B
Technician A says to pull a fusible link from both ends to check and see if the link has
broken. Technician B says to pierce the wire with your DVOM test leads to check the
link. Who's correct?
Tech A
Tech B
Both
Neither - Tech A
Two technicians are talking about repairing a dash circuit board. Tech A states a 60/40
solder with no flux is recommended. Tech B states a Rosin core solder is
recommended. Who's correct?
Tech A
Tech B
Both
Neither - Tech A
A no crank job is sent to your service bay. Tech A says to check if the motor is locked
up by hand turning the crank shaft pulley nut. Tech B says to check the battery
condition. Which is the proper first step?
Tech A
Tech B
Both A and B
Neither A nor B - Tech B
QUESTIONS AND ANSWERS 2022
A technician is performing a load test on a battery and finds the battery to below
specifications. Which of the following is the best action to taken next? a Perform a
resistance test on the battery
b Recharge the battery and sell it as a used battery
c Recharge the battery and retest it
d Drain the battery completely and recharge it - c Recharge the battery and retest it
Two technicians are discussing a whining noise heard through the radio. Technician A
says a faulty alternator stator can cause the problem. Technician B says a faulty diode
is most likely the cause. Who's correct?
Tech A
Tech B
Both A and B
Neither A nor B - Both A and B
Technician A says to pull a fusible link from both ends to check and see if the link has
broken. Technician B says to pierce the wire with your DVOM test leads to check the
link. Who's correct?
Tech A
Tech B
Both
Neither - Tech A
Two technicians are talking about repairing a dash circuit board. Tech A states a 60/40
solder with no flux is recommended. Tech B states a Rosin core solder is
recommended. Who's correct?
Tech A
Tech B
Both
Neither - Tech A
A no crank job is sent to your service bay. Tech A says to check if the motor is locked
up by hand turning the crank shaft pulley nut. Tech B says to check the battery
condition. Which is the proper first step?
Tech A
Tech B
Both A and B
Neither A nor B - Tech B
