NEIEP 700 final Review (Latest
Update) Questions and Verified Answers
100% Correct {Grade A}
Which of the following would be used to troubleshoot a controller problem? -correct
answer Straight-line wiring diagram
In the single automatic push button system (SAPB) how many calls can be registered
at one time? -correct answer One call at a time
What type of elevator control passes up hall calls in the down direction and down hall
calls in the up direction? -correct answer Selective collective control
What does the following symbol represent? -correct answer Poly/Three-phase
rectifier
What do the following symbols represent? -correct answer N.C. mechanically
operated switch
Which of the following statements is correct when connecting a meter in a circuit to
measure current? -correct answer The meter will be damaged if connected across a
voltage source
When using the digital multimeter, what jack is the red lead plugged into for all
measurements except current? -correct answer Volts/ohm jack
, NEIEP 700 final Review (Latest
Update) Questions and Verified Answers
100% Correct {Grade A}
What is the function SW position used to measure DC voltage on a digital meter? -
correct answer V with 3 dots and a line on top
What is the primary reason AC relays hum or chatter? -correct answer AC cycle
reversal
Which of the following best describes the contact rating of a magnetic switch? -
correct answer The maximum voltage and current that can be safely interrupted
How can you reduce contact arcing on plug-in relay contacts? -correct answer Wire
two contacts of the same relay in series
How are latching relays reset? -correct answer Electrically
Testing with a multimeter, full line voltage is read directly across the door close relay
coil. The coil however will not pull in. Which of the following is most likely the
problem? -correct answer Open coil
When working on unfamiliar wiring diagrams, what are good clues to finding contact
numbers? -correct answer Tracing self-holding contacts
Update) Questions and Verified Answers
100% Correct {Grade A}
Which of the following would be used to troubleshoot a controller problem? -correct
answer Straight-line wiring diagram
In the single automatic push button system (SAPB) how many calls can be registered
at one time? -correct answer One call at a time
What type of elevator control passes up hall calls in the down direction and down hall
calls in the up direction? -correct answer Selective collective control
What does the following symbol represent? -correct answer Poly/Three-phase
rectifier
What do the following symbols represent? -correct answer N.C. mechanically
operated switch
Which of the following statements is correct when connecting a meter in a circuit to
measure current? -correct answer The meter will be damaged if connected across a
voltage source
When using the digital multimeter, what jack is the red lead plugged into for all
measurements except current? -correct answer Volts/ohm jack
, NEIEP 700 final Review (Latest
Update) Questions and Verified Answers
100% Correct {Grade A}
What is the function SW position used to measure DC voltage on a digital meter? -
correct answer V with 3 dots and a line on top
What is the primary reason AC relays hum or chatter? -correct answer AC cycle
reversal
Which of the following best describes the contact rating of a magnetic switch? -
correct answer The maximum voltage and current that can be safely interrupted
How can you reduce contact arcing on plug-in relay contacts? -correct answer Wire
two contacts of the same relay in series
How are latching relays reset? -correct answer Electrically
Testing with a multimeter, full line voltage is read directly across the door close relay
coil. The coil however will not pull in. Which of the following is most likely the
problem? -correct answer Open coil
When working on unfamiliar wiring diagrams, what are good clues to finding contact
numbers? -correct answer Tracing self-holding contacts
