GRADED A+ 100% GUARANTEED SUCCESS.
The CFT was designed to evaluate which of the following? ANS >>>
Answer: Stamina, Agility, Strength
Which equipment is required for a CFT? ANS >>> Calibrated scale, dummy
grenades, and measuring tape
As a CFT monitor, you must assist in the risk management (RM) process
for the CFT. Which of the following describes the RM process steps? ANS
>>> Identifying hazards, assessing risks, determining which risks are most
important, implementing controls, and supervising the participants
The CFT monitor is responsible for setting up the events, scoring
accurately, using proper equipment, and __________ ANS >>> ensuring
participants wear the proper uniform
, Which of the following are tasks performed by the CFT monitor during
an actual CFT? ANS >>> Ensuring proper technique, calling out
repetitions.
Location choices for the movement to contact event include outdoor or
indoor venue. What are the minimum location requirements you will
need to meet? ANS >>> Reasonable level, few to no obstacles
During the manoeuvre to contact event when may Marines remove
uniform blouses? ANS >>> With the commander's authorization
As a CFT monitor, you have setup the movement to contact event on an
out-and-back route. The start and finish lines are the same. What is the
minimum number of monitors required for this route? ANS >>> 3
The participant's goal during the movement to contact event is to
_______ ANS >>> finish as quickly as possible
SSgt Winifred Carter a 28-year-old female, ran the movement to contact
event in 3:18. What is her score for the movement to contact event?
ANS >>> 95
What are the equipment requirements for ammunition cans used in the
ammunition lift event? ANS >>> The contents should not move
excessively when lifted, grip tape applied to the can sides, and use
M2A1 5.56mm cans only.