Week 7 American Gunsmith Article Quiz: FTT 201 Firearms Finishes and Engraving | Answered Latest 2025/26 - Sonoran Desert School.

Week 7 American Gunsmith Article Quiz: FTT 201 Firearms Finishes and Engraving Score for this quiz: 10 out of 10  Question 1 1 / 1 pts True False  Question 2 1 / 1 pts water transfer imaging • Quizzes must be completed and submitted by Sunday 11:59 PM of the week in which they are due. There are no exceptions. The quizzes cannot be opened after the due date has passed, not even by faculty or student success coaches. Requests to open quizzes to complete them after the due date will not be considered. • You have only ONE attempt at completing a quiz. Quizzes cannot be reset for multiple attempts. Air bubbles forming during the dip process will have no negative impact on the final product. All of the following are other names for hydrographics except: liquid printing water printing film adhesion image transfer  Question 3 1 / 1 pts It’s easier to hold a part at that angle. It prevents air bubbles from forming. The film won’t adhere if held at any other angle.  Question 4 1 / 1 pts ignite still work fine not adhere to the part make the film brittle  Question 5 1 / 1 pts True False Why is the part held at a 30 degree angle and slowly dipped into the tank? If water gets on top of the film, it will: Hydrographic printing is only available as an aftermarket modification, as manufacturers do not use it on factory firearms.  Question 6 1 / 1 pts only submerge the part of the object you want printed dip the whole thing and scrape off the areas you don’t want covered avoid those areas when painting plug holes and mask areas not to be painted or printed.  Question 7 1 / 1 pts True False  Question 8 True False  Question 9 1 / 1 pts No answers are correct to prevent overspray of the activator into the rest of the tank to prevent the film from expanding too far, causing the image to become distorted to make for easier cleanup. Your answer is correct. To prevent paint or ink from reaching undesirable places such as the inside of parts, you should: It doesn’t matter what color base coat is used because it will be entirely covered by the film. Some patterns of hydrographic film have a directional orientation, or “right side up” that needs to be kept in mind while dipping parts. The purpose of the masking tape border on the film is: 8/21/24, 7:56 PM Week 7 American Gunsmith Article Quiz: FTT 201 Firearms Finishes and Engraving  Question 10 1 / 1 pts Correct! True False Quiz Score: 10 out of 10 Areas of the firearm that have had hydrographics applied do not need to be oiled and will not rust.