SOS Mechanic Certification- Brakes 2025/2026
Complete Questions And Correct Answers
(Verified Answers)|Brand New Version!
Save
Terms in this set (83)
Most 1995 & newer Sealed non-serviceable
vehicles use which of the
following types of wheels
bearings on non-drive
wheel?
to test a vacuum power drop slightly and remain firm
brake booster in the
vehicle, you should pump
the brake pedal at least 4
times, hold the brake
pedal depressed, and
start the engine. the brake
pedal should:
You are installing a set of Smaller and goes towards the front of the car.
brake shoe linings that are
not the same length.
Traditionally, the primary
shoe lining is:
, A cracked or torn vacuum a hard pedal feel requiring very high pedal effort to
diaphragm in a brake stop
power booster would
most likely cause:
A mechanic finds gear A plugged axle
lube inside both rear
brake drums on a rear
wheel drive vehicle. What
is the most likely cause of
this problem?
Which of the following master cylinder push rod adjusted too long
incorrect service
procedures will cause
brake lock-up?
Which of the following Pump the brake pedal at least 25 times (or more,
describes the proper way depending on the manufacturer's recommendation)
to depressurized an ABS with the ignition off.
system?
The rear brakes are technician use the parking brake to adjust shoes and
dragging after having new the cable is stuck
linings installed and the
drums machined. the most
likely cause is the:
When turning brake use a dampening strap to reduce chatter
drums:
Which of the following is run-out
NOT a necessary drum
brake measurement?
On a 3-channel system, both rear wheels
which wheels are on the
same circuit?
Complete Questions And Correct Answers
(Verified Answers)|Brand New Version!
Save
Terms in this set (83)
Most 1995 & newer Sealed non-serviceable
vehicles use which of the
following types of wheels
bearings on non-drive
wheel?
to test a vacuum power drop slightly and remain firm
brake booster in the
vehicle, you should pump
the brake pedal at least 4
times, hold the brake
pedal depressed, and
start the engine. the brake
pedal should:
You are installing a set of Smaller and goes towards the front of the car.
brake shoe linings that are
not the same length.
Traditionally, the primary
shoe lining is:
, A cracked or torn vacuum a hard pedal feel requiring very high pedal effort to
diaphragm in a brake stop
power booster would
most likely cause:
A mechanic finds gear A plugged axle
lube inside both rear
brake drums on a rear
wheel drive vehicle. What
is the most likely cause of
this problem?
Which of the following master cylinder push rod adjusted too long
incorrect service
procedures will cause
brake lock-up?
Which of the following Pump the brake pedal at least 25 times (or more,
describes the proper way depending on the manufacturer's recommendation)
to depressurized an ABS with the ignition off.
system?
The rear brakes are technician use the parking brake to adjust shoes and
dragging after having new the cable is stuck
linings installed and the
drums machined. the most
likely cause is the:
When turning brake use a dampening strap to reduce chatter
drums:
Which of the following is run-out
NOT a necessary drum
brake measurement?
On a 3-channel system, both rear wheels
which wheels are on the
same circuit?
