Virginia HIC Exam Questions and Answers 100%
Correct| Newest! ! The MOST specific
Save
Practice questions for this set
Learn 1 /7 Study using Learn
Squash blocks
Choose an answer
The MOST specific information about
What is used to prevent buckling at
1 2 the size and location of windows
points of high stress?
would be found in a
Where do you start laying parquet What is NOT required in exterior
3 4
flooring nonbearing walls?
Don't know?
Terms in this set (124)
, The MOST specific Floor plan
information about the size
and location of windows
would be found in a
What direction does heat Hot to cold
flow?
What are batter boards stakes and ledger boards marking building lines
What is the MAXIMUM 3 feet
distance between a
ventilating opening in an
under-floor space and
each corner of the
building?
What is NOT required in Load-bearing headers
exterior nonbearing
walls?
A lengthwise grain Shake (c 326)
separation between or
through the growth rings
of lumber is called a
The abbreviation "d" in Penny
"16d" means
Notches may not be Middle 1/3
located in the ____________ of
a joist span
How should board and 1 inch overlap 10d nails
batten be installed?
What is the maximum 1/6 the depth of the member
allowable notch in ceiling
joists
How MUST rafters be Gusset plate (R802.3)
framed to each other
Correct| Newest! ! The MOST specific
Save
Practice questions for this set
Learn 1 /7 Study using Learn
Squash blocks
Choose an answer
The MOST specific information about
What is used to prevent buckling at
1 2 the size and location of windows
points of high stress?
would be found in a
Where do you start laying parquet What is NOT required in exterior
3 4
flooring nonbearing walls?
Don't know?
Terms in this set (124)
, The MOST specific Floor plan
information about the size
and location of windows
would be found in a
What direction does heat Hot to cold
flow?
What are batter boards stakes and ledger boards marking building lines
What is the MAXIMUM 3 feet
distance between a
ventilating opening in an
under-floor space and
each corner of the
building?
What is NOT required in Load-bearing headers
exterior nonbearing
walls?
A lengthwise grain Shake (c 326)
separation between or
through the growth rings
of lumber is called a
The abbreviation "d" in Penny
"16d" means
Notches may not be Middle 1/3
located in the ____________ of
a joist span
How should board and 1 inch overlap 10d nails
batten be installed?
What is the maximum 1/6 the depth of the member
allowable notch in ceiling
joists
How MUST rafters be Gusset plate (R802.3)
framed to each other
