1
Copyright © 2021 Pearson Education, Inc.
br br br br br
VERIFIEDBRAINBOOSTER
,Automotive Steering, Suspension, & Alignment, 8e (Halderman) br br br br br br br
Appendix 1 br
1) A customer complains that the steering lacks power assist all the time. Technician A says that t
br br br br br br br br br br br br br br br br
he power steering pump drive belt could be slipping or loose. Technician B says that worn outer tie
br br br br br br br br br br br br br br br br br b
rod ends could be the cause. Which technician is correct?
r br br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
2) A front-wheel-
br
drive vehicle pulls toward the right during hard acceleration. The most likely cause is
br br br br br br br br br br br br br br .
A) worn or defective tires br br br
B) leaking or defective shock absorbers br br br br
C) normal torque steer br br
D) a defective power steering rack-and-
br br br br
pinion steering assembly Answer: C
br br br b r
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
br br br br br br br br br br br br br br
.
A) remove the original using a special tool br br br br br br
B) install and tighten the replacement with the front wheels in the straight-ahead position
br br br br br br br br br br br br
C) grease the joint before installing on the vehicle
br br br br br br br
D) install the replacement using a special clamp vise
br br br br br br br br
Answer: B b r
4) Whenever installing a tire on a rim, do not exceed br br br br br br br br br br .
A) 25 PSI br
B) 30 PSI br
C) 35 PSI br
D) 40 PSI br
Answer: D b r
5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best bal
br br br br br br br br br br br br br br br br
ance, the tire should be match mounted. Technician B says that silicone spray should be used to lu
br br br br br br br br br br br br br br br br br
bricate the tire bend. Which technician is correct?
br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
2
Copyright © 2021 Pearson Education, Inc. br br br br br
VERIFIEDBRAINBOOSTER
,6) Technician A says that radial tires should only be rotated front to rear, never side to side. T
br br br br br br br br br br br br br br br br br
echnician B says that vehicle manufacturers usually recommend that radial tires should be rot
br br br br br br br br br br br br br
ated using the modified X method. Which technician is correct?
br br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: B b r
7) For a tire that has excessive radial runout, Technician A says that it should be broken down on a t
br br br br br br br br br br br br br br br br br br br
ire-
changing machine and then rotated 180 degrees on the wheel and retested. Technician B says that
br br br br br br br br br br br br br br br br
the tire should be replaced. Which technician is correct?
br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
8) Technician A says that overloading a vehicle can cause damage to the wheel bearings. Technic
br br br br br br br br br br br br br br
ian B says that tapered roller bearings used on a nondrive wheel should be adjusted hand tight only
br br br br br br br br br br br br br br br br br br
after seating. Which technician is correct?
br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: C b r
9) Defective wheel bearings usually sound like br br br br br br .
A) a growl
br
B) a rumble
br
C) snow tires br
D) All of the above br br br br
Answer: D b r
10) Defective outer CV joints usually make a clicking noise br br br br br br br br br
A) only when backing br br
B) while turning and moving br br br
C) while turning only br br
D) during braking br b
Answer: B
r b r
11) The proper lubricant usually specified for use in a differential is
br br br br br br br br br br br .
A) SAE 15-40 engine oil br br br
B) SAE 80W-90 GL-5 br br
C) STF
D) SAE 80W-140 GL-1 br br
3
Copyright © 2021 Pearson Education, Inc. br br br br br
VERIFIEDBRAINBOOSTER
, Answer: B
b r
4
Copyright © 2021 Pearson Education, Inc.
br br br br br
VERIFIEDBRAINBOOSTER
Copyright © 2021 Pearson Education, Inc.
br br br br br
VERIFIEDBRAINBOOSTER
,Automotive Steering, Suspension, & Alignment, 8e (Halderman) br br br br br br br
Appendix 1 br
1) A customer complains that the steering lacks power assist all the time. Technician A says that t
br br br br br br br br br br br br br br br br
he power steering pump drive belt could be slipping or loose. Technician B says that worn outer tie
br br br br br br br br br br br br br br br br br b
rod ends could be the cause. Which technician is correct?
r br br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
2) A front-wheel-
br
drive vehicle pulls toward the right during hard acceleration. The most likely cause is
br br br br br br br br br br br br br br .
A) worn or defective tires br br br
B) leaking or defective shock absorbers br br br br
C) normal torque steer br br
D) a defective power steering rack-and-
br br br br
pinion steering assembly Answer: C
br br br b r
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
br br br br br br br br br br br br br br
.
A) remove the original using a special tool br br br br br br
B) install and tighten the replacement with the front wheels in the straight-ahead position
br br br br br br br br br br br br
C) grease the joint before installing on the vehicle
br br br br br br br
D) install the replacement using a special clamp vise
br br br br br br br br
Answer: B b r
4) Whenever installing a tire on a rim, do not exceed br br br br br br br br br br .
A) 25 PSI br
B) 30 PSI br
C) 35 PSI br
D) 40 PSI br
Answer: D b r
5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best bal
br br br br br br br br br br br br br br br br
ance, the tire should be match mounted. Technician B says that silicone spray should be used to lu
br br br br br br br br br br br br br br br br br
bricate the tire bend. Which technician is correct?
br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
2
Copyright © 2021 Pearson Education, Inc. br br br br br
VERIFIEDBRAINBOOSTER
,6) Technician A says that radial tires should only be rotated front to rear, never side to side. T
br br br br br br br br br br br br br br br br br
echnician B says that vehicle manufacturers usually recommend that radial tires should be rot
br br br br br br br br br br br br br
ated using the modified X method. Which technician is correct?
br br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: B b r
7) For a tire that has excessive radial runout, Technician A says that it should be broken down on a t
br br br br br br br br br br br br br br br br br br br
ire-
changing machine and then rotated 180 degrees on the wheel and retested. Technician B says that
br br br br br br br br br br br br br br br br
the tire should be replaced. Which technician is correct?
br br br br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: A b r
8) Technician A says that overloading a vehicle can cause damage to the wheel bearings. Technic
br br br br br br br br br br br br br br
ian B says that tapered roller bearings used on a nondrive wheel should be adjusted hand tight only
br br br br br br br br br br br br br br br br br br
after seating. Which technician is correct?
br br br br br
A) Technician A only br br
B) Technician B only br br
C) Both Technicians A and B br br br br
D) Neither Technician A nor B br br br br br
Answer: C b r
9) Defective wheel bearings usually sound like br br br br br br .
A) a growl
br
B) a rumble
br
C) snow tires br
D) All of the above br br br br
Answer: D b r
10) Defective outer CV joints usually make a clicking noise br br br br br br br br br
A) only when backing br br
B) while turning and moving br br br
C) while turning only br br
D) during braking br b
Answer: B
r b r
11) The proper lubricant usually specified for use in a differential is
br br br br br br br br br br br .
A) SAE 15-40 engine oil br br br
B) SAE 80W-90 GL-5 br br
C) STF
D) SAE 80W-140 GL-1 br br
3
Copyright © 2021 Pearson Education, Inc. br br br br br
VERIFIEDBRAINBOOSTER
, Answer: B
b r
4
Copyright © 2021 Pearson Education, Inc.
br br br br br
VERIFIEDBRAINBOOSTER
