Comprehensive Practice Questions for the IAAI CFI
Certification Exam IAAI CFI EXAM BANK 2025 |
ACCURATE CURRENTLY TESTING EXAM VERSIONS
WITH REAL EXAM QUESTIONS AND ANSWERS WITH
RATIONALES AND A STUDY GUIDE | EXPERT
VERIFIED FOR GUARANTEED PASS | LATEST UPDATE
A liquid with a flash point ABOVE 100F - correct
answer..Combustible Liquid
If the current flowing out from an electrical panel is 12.5 amps,
and it then flows through an electrical load of 1500 watts, what
is the amperage of the remaining current flow of the return
circuit? - correct answer..12.5
If a hair dryer draws 8.3amps (in a home with 120-volt service),
what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts - correct answer..1000
The year of the first edition of NFPA 1033 - correct
answer..1987
The recommended distance for securing the perimeter of a blast
scene
,*That is, the distance from the furthest debris - correct
answer..1.5 times
What temperature in the upper gas layer causes the onset of
Flashover? - correct answer..1100°F
The temperature at which copper melts - correct
answer..1960°F
The measurement of the radiant heat flux (from gas layer to the
floor) that indicates the onset of flashover - correct answer..2
W/cm2
The voltage between the two hot wires at the service entrance
cables in most single-family residences in the United States
(single-phase service with three wires) - correct answer..240
volts
The revision cycle for NFPA 921 (timespan) - correct answer..3
years
The flash point of power steering fluid - correct answer..350°F
In high-pressure fuel-injected vehicles, this is the typical range
of pressure that is used to pump fuel from a fuel tank - correct
answer..35-70 p.s.i.
The lower explosive and upper explosive limit of natural gas
(methane)? - correct answer..5 and 17
,The ignition temperature of power steering fluid - correct
answer..680°F
Any substance that can undergo combustion - correct
answer..Fuel
Two factors or situations leading to a fire that may show the
nature of the incident responsibility. - correct answer..Act or
Omission
This concept should not be included in a summary report of
findings. - correct answer..Additional Investigative
Recommendations
A law that may govern the fire investigation of a boat - correct
answer..Admiralty Law
A type of device in a vehicle, which can cause an electrical
overload to factory installed wiring - correct answer..After-
market Equipment
Evidence of smoke or soot in the lungs, bronchi, and trachea is
one of the most significant factors in confirming that, at the time
of the fire, the victim was WHAT? - correct answer..Alive and
Breathing
Those who have the responsibility for monitoring safety
conditions at the fire or explosion scene - correct answer..All
Team Members
The melting temperature of aluminum - correct answer..1220°F
, Which one of these is NOT considered a competent ignition
source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks - correct answer..Aluminum-to-pavement
sparks
A meaningful analysis of a fire requires an understanding of the
fire growth, the total heat released, and WHAT? - correct
answer..Heat Release Rate
What does he term AFCI stand for? And, the "A" specifically
represents what? - correct answer..Arc-fault circuit interrupter
The organization that develops standard methods for testing
materials - correct answer..ASTM
Initiation of combustion by heat but without a spark or flame -
correct answer..Auto-ignition
A deflagration resulting from the sudden introduction of air into
a confined space containing oxygen-deficient products of
incomplete combustion - correct answer..Backdraft
An explosion caused by a combination of combustible materials
heated to the ignition point and a sudden introduction of oxygen
to support combustion - correct answer..Backdraft
Certification Exam IAAI CFI EXAM BANK 2025 |
ACCURATE CURRENTLY TESTING EXAM VERSIONS
WITH REAL EXAM QUESTIONS AND ANSWERS WITH
RATIONALES AND A STUDY GUIDE | EXPERT
VERIFIED FOR GUARANTEED PASS | LATEST UPDATE
A liquid with a flash point ABOVE 100F - correct
answer..Combustible Liquid
If the current flowing out from an electrical panel is 12.5 amps,
and it then flows through an electrical load of 1500 watts, what
is the amperage of the remaining current flow of the return
circuit? - correct answer..12.5
If a hair dryer draws 8.3amps (in a home with 120-volt service),
what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts - correct answer..1000
The year of the first edition of NFPA 1033 - correct
answer..1987
The recommended distance for securing the perimeter of a blast
scene
,*That is, the distance from the furthest debris - correct
answer..1.5 times
What temperature in the upper gas layer causes the onset of
Flashover? - correct answer..1100°F
The temperature at which copper melts - correct
answer..1960°F
The measurement of the radiant heat flux (from gas layer to the
floor) that indicates the onset of flashover - correct answer..2
W/cm2
The voltage between the two hot wires at the service entrance
cables in most single-family residences in the United States
(single-phase service with three wires) - correct answer..240
volts
The revision cycle for NFPA 921 (timespan) - correct answer..3
years
The flash point of power steering fluid - correct answer..350°F
In high-pressure fuel-injected vehicles, this is the typical range
of pressure that is used to pump fuel from a fuel tank - correct
answer..35-70 p.s.i.
The lower explosive and upper explosive limit of natural gas
(methane)? - correct answer..5 and 17
,The ignition temperature of power steering fluid - correct
answer..680°F
Any substance that can undergo combustion - correct
answer..Fuel
Two factors or situations leading to a fire that may show the
nature of the incident responsibility. - correct answer..Act or
Omission
This concept should not be included in a summary report of
findings. - correct answer..Additional Investigative
Recommendations
A law that may govern the fire investigation of a boat - correct
answer..Admiralty Law
A type of device in a vehicle, which can cause an electrical
overload to factory installed wiring - correct answer..After-
market Equipment
Evidence of smoke or soot in the lungs, bronchi, and trachea is
one of the most significant factors in confirming that, at the time
of the fire, the victim was WHAT? - correct answer..Alive and
Breathing
Those who have the responsibility for monitoring safety
conditions at the fire or explosion scene - correct answer..All
Team Members
The melting temperature of aluminum - correct answer..1220°F
, Which one of these is NOT considered a competent ignition
source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks - correct answer..Aluminum-to-pavement
sparks
A meaningful analysis of a fire requires an understanding of the
fire growth, the total heat released, and WHAT? - correct
answer..Heat Release Rate
What does he term AFCI stand for? And, the "A" specifically
represents what? - correct answer..Arc-fault circuit interrupter
The organization that develops standard methods for testing
materials - correct answer..ASTM
Initiation of combustion by heat but without a spark or flame -
correct answer..Auto-ignition
A deflagration resulting from the sudden introduction of air into
a confined space containing oxygen-deficient products of
incomplete combustion - correct answer..Backdraft
An explosion caused by a combination of combustible materials
heated to the ignition point and a sudden introduction of oxygen
to support combustion - correct answer..Backdraft
