NCCCO Final Test 2025 EXAM QUESTIONS AND CORRECT DETAILED ANSWERS WITH (VERIFIED ANSWERS) |ALREADY GRADED A+||NEWEST VERSION

NCCCO Final Test 2025 EXAM QUESTIONS AND CORRECT DETAILED ANSWERS WITH (VERIFIED ANSWERS) |ALREADY GRADED A+||NEWEST VERSION Study online at 1. Which area do truck cranes without a 5th outrigger generally have no lifting capacity unless the manufacturer states otherwise? The front 2. What is the definition of "operating radius?" The distance from the center of rotation of the crane to the center of gravity of the load 3. What applies to the capacities below the bold line shown on a load chart? They are based on the stability of the crane 4. In which quadrant are rough terrain crane capacities generally greater? Over the front 5. What percentage do most manufacturers requires a crane's load chart capacity to be reduced by for duty cycle operations - such as high-volume concrete placement? 20% 6. From which two points should the boom be measured? From the boom hinge pins, to the center of the boom tip sheave 7. What is the preferred method of installing wire rope from a reel onto a hoist drum? Running the rope from the top of the reel, to the top of the drum. 1 / 6 NCCCO Final Test 2025 EXAM QUESTIONS AND CORRECT DETAILED ANSWERS WITH (VERIFIED ANSWERS) |ALREADY GRADED A+||NEWEST VERSION Study online at 8. Over which quadrant are truck crane capacities usually greater? Over the rear 9. According to OSHA, which accessible area of an operating crane must always be barricaded? The swing radius of the rear of the rotating superstructure 10. What is the OSHA regulation governing cranes in construction? 1926.1400 11. According to ASME, what percentage of the manufacturer's crane rating must not be exceeded if a load test is done on a repaired crane? 100% 12. Where is the tipping axis of a crawler crane located? It depends if the idler or sprocket are in line or offset from the track rollers 13. What should be done with materials placed under overhead energized power lines? NOT be lifted by crane 14. What determines the amount of deduction required for an erected jib that is not being used? The effective weight of the jib 15. It increases 2 / 6 NCCCO Final Test 2025 EXAM QUESTIONS AND CORRECT DETAILED ANSWERS WITH (VERIFIED ANSWERS) |ALREADY GRADED A+||NEWEST VERSION Study online at What happens to ground bearing pressure if you move a crawler crane from soft ground to harder ground? 16. How should the wheels of a crane be positioned when it is set up for working on outriggers? Just high enough off the ground to relieve the tires of crane weight 17. Where are the Standard Method hand signals found? OSHA Subpart CC 18. A truck crane is set up on outriggers. The part of the load chart governed by stability is based on what percentage of the cranes capacity? 85% 19. Truck crane capacities are usually greater over the _________ Rear 20. If the operator makes two audible signals when moving a crane, he/she intends to ______________ Go ahead 21. Blocking (Cribbing) may be placed under outrigger beams: Never. 22. Make the crane more stable 3 / 6