DANTE CERTIFICATION LEVEL 2 PART A |40 COMPLETE AND
GRADED QUESTIONS AND ANSWERS 2026 LATEST UPDATED | 100%
GRADED CORRECT | 100% GUARANTEED TO PASS | GET A+
What does Dante redundancy do? - (ANSWER)Feature that allows glitch-free flow of audio
through a Secondary network when the Primary network fails for any reason
Can the Secondary (redundant) port on a Dante device be connected to the Primary network to
increase channel count? - (ANSWER)No. This will cause the network to fail.
How does one setup Dante redundancy? - (ANSWER)Connect a second set of cables and
switches to create a network that uses only the Secondary port of Dante devices
Can the Secondary (redundant) port be configured to daisy chain devices? - (ANSWER)Yes,
but only on certain Dante devices. Always check.
When would you select the "Enable Sync to External" box for devices on the DC Clock Status
tab? - (ANSWER)When a device is either a) connected to an external word clock, or b) when
using the internal clock of a device to drive a Dante option card
Dante [ ... ] use unicast as the default mode of transmission. - (ANSWER)does
, A unicast network connection is: - (ANSWER)- Communication that is only between specific
devices on a network
- Default Dante behavior
A multicast network connection is: - (ANSWER)- One to many
- Useful for solving "Fan out" conditions
A broadcast network connection is: - (ANSWER)- One to everyone
- Not used by Dante for audio
- A common type of network traffic
A unicast Dante Flow can contain up to [ ... ] different Tx channels of audio from the same
device. - (ANSWER)4
How does Dante Controller inform you that multicast is recommended? - (ANSWER)With a
"Fan out' warning.
Dante Multicast Flows are manually created on an as needed basis. - (ANSWER)True
GRADED QUESTIONS AND ANSWERS 2026 LATEST UPDATED | 100%
GRADED CORRECT | 100% GUARANTEED TO PASS | GET A+
What does Dante redundancy do? - (ANSWER)Feature that allows glitch-free flow of audio
through a Secondary network when the Primary network fails for any reason
Can the Secondary (redundant) port on a Dante device be connected to the Primary network to
increase channel count? - (ANSWER)No. This will cause the network to fail.
How does one setup Dante redundancy? - (ANSWER)Connect a second set of cables and
switches to create a network that uses only the Secondary port of Dante devices
Can the Secondary (redundant) port be configured to daisy chain devices? - (ANSWER)Yes,
but only on certain Dante devices. Always check.
When would you select the "Enable Sync to External" box for devices on the DC Clock Status
tab? - (ANSWER)When a device is either a) connected to an external word clock, or b) when
using the internal clock of a device to drive a Dante option card
Dante [ ... ] use unicast as the default mode of transmission. - (ANSWER)does
, A unicast network connection is: - (ANSWER)- Communication that is only between specific
devices on a network
- Default Dante behavior
A multicast network connection is: - (ANSWER)- One to many
- Useful for solving "Fan out" conditions
A broadcast network connection is: - (ANSWER)- One to everyone
- Not used by Dante for audio
- A common type of network traffic
A unicast Dante Flow can contain up to [ ... ] different Tx channels of audio from the same
device. - (ANSWER)4
How does Dante Controller inform you that multicast is recommended? - (ANSWER)With a
"Fan out' warning.
Dante Multicast Flows are manually created on an as needed basis. - (ANSWER)True
